ST72T311 ST Microelectronics, ST72T311 Datasheet - Page 82

• Manufacturer Part Number: ST72T311
• Description: 8-BIT MCU WITH 8 TO 16K OTP/EPROM
• Manufacturer: ST Microelectronics

ST72E311 ST72T311
ST7 ADDRESSING MODES (Cont’d)
5.1.6 Indirect Indexed (Short, Long)
This is a combination of indirect and short indexed
addressing modes. The operand is referenced by
its memory address, which is defined by the un-
signed addition of an index register value (X or Y)
with a pointer value located in memory. The point-
er address follows the opcode.
The indirect indexed addressing mode consists of
two sub-modes:
Indirect Indexed (Short)
The pointer address is a byte, the pointer size is a
byte, thus allowing 00 - 1FE addressing space,
and requires 1 byte after the opcode.
Indirect Indexed (Long)
The pointer address is a byte, the pointer size is a
word, thus allowing 64 Kbyte addressing space,
and requires 1 byte after the opcode.
Table 23. Instructions Supporting Direct,
Indexed,
Addressing Modes
82/100
Short Instructions Only
LD
CP
AND, OR, XOR
ADC, ADD, SUB, SBC
BCP
CLR
INC, DEC
TNZ
CPL, NEG
BSET, BRES
BTJT, BTJF
SLL, SRL, SRA, RLC,
RRC
SWAP
CALL, JP
Long and Short
Instructions
82
Indirect
and
Clear
Increment/Decrement
Test Negative or Zero
1 or 2 Complement
Bit Operations
Bit Test and Jump Opera-
tions
Shift and Rotate Operations
Swap Nibbles
Call or Jump subroutine
Load
Compare
Logical Operations
Arithmetic Addition/subtrac-
tion operations
Bit Compare
Indirect
Functio n
Function
Indexed
5.1.7 Relative mode (Direct, Indirect)
This addressing mode is used to modify the PC
register value, by adding an 8-bit signed offset to
it.
The relative addressing mode consists of two sub-
modes:
Relative (Direct)
The offset is following the opcode.
Relative (Indirect)
The offset is defined in memory, which address
follows the opcode.
Available Relative Direct/
JRxx
CALLR
Indirect Instructions
Conditional Jump
Call Relative
Function