ST72T311 ST Microelectronics, ST72T311 Datasheet - Page 100

• Manufacturer Part Number: ST72T311
• Description: 8-BIT MCU WITH 8 TO 16K OTP/EPROM
• Manufacturer: ST Microelectronics

ST72E311 ST72T311
8 SUMMARY OF CHANGES
Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences
of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted
by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject
to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not
authorized for use as critical components in life support devices or systems without the express written approval of STMicroelectronics.
100/100
Added note ”Any modification of one of these two bits resets the interrupt request related to
this interrupt vector.”
Australia - Brazil - China - Finland - France - Germany - Hong Kong - India - Italy - Japan - Malaysia - Malta - Morocco - Singapore - Spain
Purchase of I
Added new External Connections section
Removed RP external resistor
Changed ORed to ANDed in External interrupts paragraph, to read “If several input pins, con-
nected to the same interrupt vector, are configured as interrupts, their signals are logically AN-
Ded before entering the edge/level detection block”.
Added clamping diodes to I/O pin figure and table
Added sections on low power modes and interrupts to peripheral descriptions
Changed 16-bit Timer chapter
Added details to description of FOLV1 and FOLV2 bits
Added ADC recommended external connections
Added Reset characteristics section
Added min. value for V
Added figure to ADC Converter Specification
Removed ST72311 ROM device (supported by ST72314)
SPR2 bit reinstated in SPI chapter
I
2
2
C Components by STMicroelectronics conveys a license under the Philips I
C system is granted provided that the system conforms to the I
LVDUP
Change Description (Rev. 1.5 to 1.6)
Change Description (Rev. 1.6 to 1.7)
The ST logo is a registered trademark of STMicroelectronics
Sweden - Switzerland - United Kingdom - U.S.A.
1999 STMicroelectronics - All Rights Reserved.
STMicroelectronics Group of Companies
http:// www.st.com
2
C Standard Specification as defined by Philips.
2
C Patent. Rights to use these components in an
34, 47, 60, 74, 79
21 and 27
36 to 52
64 to 76
Page
10
18
26
29
48
79
90
90
91