AT83C24NDS-PRRUM ATMEL [ATMEL Corporation], AT83C24NDS-PRRUM Datasheet - Page 17

• Manufacturer Part Number: AT83C24NDS-PRRUM
• Description: Smart Card Reader Interface with Power Management
• Manufacturer: ATMEL [ATMEL Corporation]

Transparent Mode
4234F–SCR–10/05
•
•
•
•
•
•
It is a self-timed sequence which cannot be interrupted when started (see Figure 13). Each step
is separated by a delay based on Td equal to 8 periods of the DC/DC clock, typically 2 µs:
Notes:
If the microcontroller outputs ISO 7816 signals, a transparent mode allows to connect RST/CLK
and I/O/C4/C8 signals after an electrical level control. The AT83C24 level shifters adapt the card
signals to the smart card voltage selection.
The CRST and CCLK microcontroller signals can be respectively connected to the A1/RST and
A2/CK pins.
The CRST_SEL bit (in CONFIG4 register) selects standard or transparent configuration for the
CRST pin. CKS in CONFIG2 allows to select standard or transparent configuration for the CCLK
pin. So CCLK and CRST are independent. A2/CK to A0/3V inputs always give the TWI address
at reset. The A0/3V pin can be used for TWI addressing and easily connect two AT83C24
devices on the same TWI bus.
Figure 13. Deactivation Sequence
VCARDERR bit is set by hardware (or by software)
INSERT is set and CARDIN is cleared (card extraction)
SHUTDOWN is set by software
CMDVCC goes from Low to High
Power fail on VCC (see POWERMON bit in CONFIG4 register)
Reset pin going low
1. T0: CARDRST is cleared, SHUTDOWN bit set.
2. T0 + 5 x Td:CARDCK is cleared, CKSTOP, CARDIO and IODIS are set.
3. T0 + 6 x Td: CARDIO is cleared.
4. T0 + 7 x Td: VCARD[1-0] = 00.
1. Setting ICARDERR by software does not trigger a deactivation. VCARDERR can be used to
2. t1=5 to 5.5*Td, and t2=0.5*Td to Td.
deactivate the card by software.
CCLK
CRST
CVCC
CIO,
CC4,
CC8
t1
t2
Td
AT83C24
17