kac-9630 ETC-unknow, kac-9630 Datasheet - Page 20

• Manufacturer Part Number: kac-9630
• Description: Cmos Image Sensor 126 H X 98 V Ultra Sensitive Global Shutter 580 Fps Monochrome Cis
• Manufacturer: ETC-unknow

IMAGE SENSOR SOLUTIONS
Test Circuitry
Note 1:
Note 2:
Note 3:
Note 4:
Note 5:
Note 6:
Note 7:
Note 8:
Note 9:
Note 10: The dew point temperature (the temperature below which there is a possibility of moisture condensation forming inside the
www.kodak.com/go/imagers 585-722-4385
Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate con-
ditions for which the device is functional, but do not guarantee specific performance limits. For guaranteed specifications
and test conditions, see the Electrical Characteristics. The guaranteed specifications apply only for the test conditions
listed. Some performance characteristics may degrade when the device is not operated under the listed test conditions.
All voltages are measured with respect to GND = AGND = DGND = 0V, unless otherwise specified.
When the voltage at any pin exceeds the power supplies (VIN < GND or VIN > vdd_ana or vdd_od), the current at that pin
should be limited to 25mA. The 50mA maximum package input current rating limits the number of pins that can safely
exceed the power supplies with an input current of 25mA to two.
The absolute maximum junction temperature (TJmax) for this device is 125
is dictated by TJmax, the junction-to-ambient thermal resistance (Θ
culated using the formula PDMAX = (TJmax - TA)/Θ
1.8W at the maximum operating ambient temperature of 50
operation will typically be about 130 mW. The values for maximum power dissipation listed above will be reached only
when the KAC-9630 is operated in a severe fault condition.
Human body model is 100pF capacitor discharged through a 1.5kΩ resistor. Machine model is 220pF discharged through
ZERO Ohms.
See AN450, “Surface Mounting Methods and Their Effect on Product Reliability”, or the section entitled “Surface Mount”
found in any post 1986 National Semiconductor Linear Data Book, for other methods of soldering surface mount devices.
The analog inputs are protected as shown below. Input voltage magnitude up to 500mV beyond the supply rails will not
damage this device. However, input errors will be generated If the input goes above vdd_ana and below AGND.
Typical figures are at TJ = 25
Test limits are guaranteed to AOQL (Average Outgoing Quality Level).
package) of the package is rated at -10
sensor between -40
o
C and -10
o
C, and represent most likely parametric norms
0
C.
Pad
o
C. Suitable precautions should be taken to avoid dew formation when operating the
IOP
JA
. In the 32-pin LCC, Θ
VDD
20
VSS
o
C. Note that the power dissipation of this device under normal
JA
), and the ambient temperature (TA), and can be cal-
Internal Circuits
JA
o
C. The maximum allowable power dissipation
is 41.6
o
C/W, so PDMAX = 2.4W at 25
Email:[e-mail]
o
C and