saa5355 NXP Semiconductors, saa5355 Datasheet - Page 21
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
saa5355
Manufacturer Part Number
saa5355
Description
Single-chip Colour Crt Controller Ftfrom
Manufacturer
NXP Semiconductors
Datasheet
1.SAA5355.pdf
(31 pages)
Philips Semiconductors
Scroll map
The scroll map uses a 26-byte area of on-chip RAM and functions in association with the timing chain. It maps the scan
row on to the fetched memory row so allowing the stored page to be displayed in any row order. For each row, a 1-byte
pointer to the display memory row is stored in the scroll map. This allows scrolling without the need for data transfer to,
or from, side storage.
Additional control bits are stored, allowing 1 to 25 rows to be displayed at any location on the screen.
Colour map and digital-to-analogue converters
The colour map RAM contains thirty-two 12-bit words that are loaded by the microprocessor and read out in three 4-bit
groups at pixel rate. Each group is fed to a non-linear (gamma-corrected) D-A converter. The resulting R, G and B outputs
are low-impedance with peak-to-peak amplitudes controlled by the reference voltage applied at pin 21.
Cursor
The cursor is available in the stack mode. Its position, character code, character table, foreground colour, background
colour, lining and flash attributes are all software programmable via internal register bits.
NON-VIDEOTEX APPLICATIONS
For non-Videotex applications, the device will also support the following operating modes:
Explicit fill mode. An alternative 40 character/rows mode which does not use the memory compression technique of
stack coding. More display memory is required but there are no limitations on the number of display attribute changes
per row.
80 characters/rows mode. When operating with 80 characters per row, the available display attributes are eight
foreground colours, eight (potentially different) background colours (including transparent) as well as underline and blink.
Full field DRCS mode. This mode is not mutually exclusive to the explicit fill and 80 characters/rows modes but rather
the available DRCS memory is expanded so that the whole screen can be covered, thus enabling a ‘bit map’. All
ROM-based characters and all display attributes remain available.
MICROPROCESSOR and RAM BUS INTERFACE
Three types of data transfer take place at the bus interface:
FTFROM access to display memory (Figs 17 and 18)
FTFROM accesses the external display memory via a 16-bit multiplexed address and data bus with a cycle time of
496,5 ns (F6 = 6,041957 MHz). The address strobe (AS) signal from FTFROM flags the bus cycle and writes the address
into octal latches (74LS373). The display data is stored in bytes of upper (most-significant) and lower (least-significant)
display information and is always fetched in pairs of bytes (upper
sections are enabled simultaneously by the upper and lower data strobes (respectively UDS and LDS) which are always
asserted together to fetch a 16-bit word. The read/write control R/W is included although FTFROM only reads from the
display memory.
March 1986
FTFROM fetches data from the display memory
The microprocessor reads from, or writes to, FTFROM’s internal register map
The microprocessor accesses the display memory
Single-chip colour CRT controller
(FTFROM)
21
lower = 16 bits). The upper and lower display RAM
Product specification
SAA5355