s5u1c88104d Epson Electronics America, Inc., s5u1c88104d Datasheet - Page 13

• Manufacturer Part Number: s5u1c88104d
• Description: Cmos 8-bit Single Chip Microcomputer
• Manufacturer: Epson Electronics America, Inc.

3. Error messages
S5U1C88104D MANUAL
(DEVELOPMENT SOFTWARE TOOL FOR S1C88104)
<Messages of installer>
1. Start-up message
2. Setting, confirmation and operating messages
Enter install drive from
Enter copy drive & path to
Caution : Install and copy drive must be set different name
Insert install disk [volume name] to specified drive
Copy drive and path is [drive and path name]
Enter appends a path from default setting (max 40 char)
Install drive from : [Install drive and path name]
Copy drive to : [Copy drive and path name]
Copying [reading file]
to [writing file]
Press any key to continue
Press any key to exit
E0C88 Family Dev. Tools install utility has been successfully
Good-bye from E0C88 Family Dev. Tools install utility
Incorrect DOS Version use DOS 3.X or later
Write protect error
Unit No. is not exist
Drive not ready
Install disk is different
Seek error
Media type is different
Sector not found
Write error
Read error
Other error
Disk error on [drive]
Cannot create the path
Setting path already exists enter another drive and path
Insufficient disk space
Insufficient disk space, insert other disk
Bad select the install drive
Bad select the copy drive
Error : [Reading file] Cannot open source file
Error : [Writing file] Cannot open out file
E0C88 Family Dev. Tools install utility has been terminated
Caution : Delete temporary installed and files
E0C88 Family Development Tool Install Utility Ver. X.XX
Copyright (C) SEIKO EPSON CORP. 1995–1996
Error message
Message
Transfer source drive name
Transfer destination drive name
Transfer source drive name and transfer destination drive name
must be set to different names.
Insert the transfer source disk [volume name] into the specified drive.
Transfer destination drive and path is [drive name and path name].
Input path name appending to the default setting.
Transfer source drive is [drive name and path name].
Transfer destination drive is [drive name and path name].
Reading transfer source file [file name].
Writing transfer destination file [file name].
Press any key to continue the installer.
Press any key to terminate the installer.
Installation of the S1C88 Family software tools has been succeeded.
Terminates installation of the S1C88 Family software tools.
DOS version is incorrect.
Transfer destination disk has been protected from writing.
There is no unit number.
The drive is not ready.
Disk to be installed is different.
Seek error has been generated.
Disk is different.
Sector cannot be detected.
Write error has been generated.
Read error has been generated.
Other error has been generated.
Disk error has been generated on [drive].
Path cannot be created.
Since the set path already exists, set another drive and path.
Disk space is insufficient.
Since the disk space is insufficient, insert another disk.
Drive specification for transfer source disk is wrong.
Drive specification for transfer destination disk is wrong.
Transfer source file cannot be read.
Transfer destination file cannot be written.
Installation of the S1C88 Family software tools has been terminated.
Since the installation of the S1C88 Family software tools has been
terminated, delete all the file which are installed incompletely.
EPSON
2 DEVELOPMENTAL ENVIRONMENT AND INSTALL
Explanation
Explanation
7