sc16c752-04 NXP Semiconductors, sc16c752-04 Datasheet - Page 11

• Manufacturer Part Number: sc16c752-04
• Description: Sc16c752 Dual Uart With 64-byte Fifo
• Manufacturer: NXP Semiconductors

Philips Semiconductors
9397 750 11635
Product data
6.4 Reset
60 characters have been sent. At this time, UART2 will transmit a 0F to UART1,
informing UART1 to halt transmission. UART1 will likely send the 61
UART2 is sending the Xoff character. Now UART2 is serviced and the processor
reads enough data out of the RX FIFO that the level drops to 32. UART2 will now
send a 0D to UART1, informing UART1 to resume transmission.
Table 4
Table 4:
[1]
Table 5
Table 5:
Register
Interrupt enable register
Interrupt identification register
FIFO control register
Line control register
Modem control register
Line status register
Modem status register
Enhanced feature register
Receiver holding register
Transmitter holding register
Transmission control register
Trigger level register
Signal
TX
RTS
DTR
RXRDY
TXRDY
Registers DLL, DLH, SPR, Xon1, Xon2, Xoff1, Xoff2 are not reset by the top-level reset signal
RESET, i.e., they hold their initialization values during reset.
summarizes the state of register after reset.
summarizes the state of registers after reset.
Register reset functions
Signal RESET functions
Rev. 04 — 20 June 2003
Reset control
RESET
RESET
RESET
RESET
RESET
RESET
RESET
RESET
RESET
RESET
RESET
RESET
Reset control
RESET
RESET
RESET
RESET
RESET
Reset state
All bits cleared.
Bit 0 is set. All other bits cleared.
All bits cleared.
Reset to 00011101 (1D hex).
All bits cleared.
Bits 5 and 6 set. All other bits cleared.
Bits 0-3 cleared. Bits 4-7 input signals.
All bits cleared.
Pointer logic cleared.
Pointer logic cleared.
All bits cleared.
All bits cleared.
Reset state
high
high
high
high
low
© Koninklijke Philips Electronics N.V. 2003. All rights reserved.
Dual UART with 64-byte FIFO
SC16C752
st
character while
11 of 47