m95256 STMicroelectronics, m95256 Datasheet - Page 22
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
m95256
Manufacturer Part Number
m95256
Description
256 Kbit Serial Spi Bus Eeprom With High Speed Clock
Manufacturer
STMicroelectronics
Datasheet
1.M95256.pdf
(43 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
m95256-DFMC6TG
Manufacturer:
STMicroelectronics
Quantity:
950
Part Number:
m95256-DFMC6TG
Manufacturer:
ST
Quantity:
20 000
Part Number:
m95256-DRDW3TP/K
Manufacturer:
ST
Quantity:
20 000
Part Number:
m95256-DRMN3TP/K
Manufacturer:
ST
Quantity:
20 000
Instructions
5.6
22/43
Write to Memory Array (WRITE)
As shown in
low. The bits of the instruction byte, address bytes, and at least one data byte are then
shifted in, on Serial Data Input (D). The instruction is terminated by driving Chip Select (S)
high at a byte boundary of the input data. The self-timed Write cycle, triggered by the rising
edge of Chip Select (S), continues for a period t
Table 18
In the case of
has been latched in, indicating that the instruction is being used to write a single byte. If,
though, Chip Select (S) continues to be driven low, as shown in
input data is shifted in, so that more than a single byte, starting from the given address
towards the end of the same page, can be written in a single internal Write cycle.
Each time a new data byte is shifted in, the least significant bits of the internal address
counter are incremented. If the number of data bytes sent to the device exceeds the page
boundary, the internal address counter rolls over to the beginning of the page, and the
previous data there are overwritten with the incoming data. (The page size of these devices
is 64 bytes).
The instruction is not accepted, and is not executed, under the following conditions:
Figure 10. Byte Write (WRITE) sequence
1. The most significant address bit (b15) is Don’t Care.
S
C
D
Q
if the Write Enable Latch (WEL) bit has not been set to 1 (by executing a Write Enable
instruction just before)
if a Write cycle is already in progress
if the device has not been deselected, by Chip Select (S) being driven high, at a byte
boundary (after the eighth bit, b0, of the last data byte that has been latched in)
if the addressed page is in the region protected by the Block Protect (BP1 and BP0)
bits.
and
Figure
Table
Figure
0
1
High Impedance
19.), at the end of which the Write in Progress (WIP) bit is reset to 0.
10, to send this instruction to the device, Chip Select (S) is first driven
2
10, Chip Select (S) is driven high after the eighth bit of the data byte
Instruction
3
4
5
6
7
15
8
14 13
9 10
16-Bit Address
WC
3
20 21 22 23 24 25 26 27
(as specified in
2
1
0
M95256, M95256-W, M95256-R
7
6
Figure
5
Table
Data Byte
4
11, the next byte of
3
28 29 30
16,
2
Table
1
0
31
17,
AI01795D