is42s16100c1 Integrated Silicon Solution, Inc., is42s16100c1 Datasheet - Page 36

• Manufacturer Part Number: is42s16100c1
• Description: 512k Words X 16 Bits X 2 Banks 16-mbit Synchronous Dynamic Ram
• Manufacturer: Integrated Silicon Solution, Inc.

36
IS42S16100C1
Bank Active Command Interval
When the selected bank is precharged, the period trp
has elapsed and the bank has entered the idle state, the
bank can be activated by executing the active
command. If the other bank is in the idle state at that
time, the active command can be executed for that bank
after the period t
banks will be in the active state. When a bank active
command has been executed, a precharge command
must be executed for
Clock Suspend
When the CKE pin is dropped from HIGH to LOW during a
read or write cycle, the IS42S16100C1 enters clock
suspend mode on the next CLK rising edge. This command
reduces the device power dissipation by stopping the
device internal clock. Clock suspend mode continues as
long as the CKE pin remains low. In this state, all inputs
other than CKE pin are invalid and no other commands can
be executed. Also, the device internal states are maintained.
When the CKE pin goes from LOW to HIGH clock suspend
mode is terminated on the next CLK rising edge and device
operation resumes.
CAS latency = 3
CAS latency = 2, burstlength = 4
COMMAND
COMMAND
COMMAND
RRD
CLK
CLK
has elapsed. At that point both
CKE
CLK
BANK ACTIVE (BANK 0)
BANK ACTIVE (BANK 0)
DQ
ACT 0
ACT 0
READ (BANK 0)
READ 0
t
t
RRD
RCD
Integrated Silicon Solution, Inc. — www.issi.com —
D
OUT
CLOCK SUSPEND
BANK ACTIVE (BANK 1)
BANK ACTIVE (BANK 0)
0
READ 0
ACT 1
that bank within the ACT to PRE command period (t
max). Also note that a precharge command cannot be
executed for an active bank before t
After a bank active command has been executed and the
trcd period has elapsed, read write (including auto-precharge)
commands can be executed for that bank.
The next command cannot be executed until the recovery
period (t
Since this command differs from the self-refresh command
described previously in that the refresh operation is not
performed automatically internally, the refresh operation
must be performed within the refresh period (tref). Thus the
maximum time that clock suspend mode can be held is just
under the refresh cycle time.
D
CKA
OUT
) has elapsed.
1
D
OUT
2
D
OUT
RAS
(min) has elapsed.
3
ISSI
1-800-379-4774
11/03/06
Rev. D
RAS
®