at88rf1354 ATMEL Corporation, at88rf1354 Datasheet - Page 37

• Manufacturer Part Number: at88rf1354
• Description: 13.56 Mhz Type B Rf Reader Specification
• Manufacturer: ATMEL Corporation

D.4.
8547A−RFID−10/08
Figure D-2. Solder mask definition for perimeter lands.
For the cases where the thermal land dimensions are close to the theoretical maximum discussed above, it is
recommended that the thermal pad area should be solder mask defined in order to avoid any solder bridging between
the thermal pad and the perimeter pads. The mask opening should be 100 microns smaller than the thermal land size
on all four sides. This will guarantee a 25 micron solder mask overlap even for the worse case misregistration.
Board Mounting Guidelines
Due to the small lead surface area and the sole reliance on the printed solder paste on the PCB surface, care must
be taken to form reliable solder joints for QFN packages. This is further complicated by the large thermal pad
underneath the package and its proximity to the inner edges of the leads. Although the pad pattern design suggested
above might help in eliminating some of the surface mounting problems, special considerations are needed in the
stencil design and the paste printing for both the perimeter and the thermal pads. Since the surface mount process
varies from company to company, careful process development is recommended. The following provides some
guidelines for the stencil design based on Atmel’s experience in the surface mounting of QFN packages.
D.4.1.
Optimum and reliable solder joints on the perimeter pads should have about 50 to 75 microns (2 to 3 mils) standoff
height and a good side fillet on the outside. A joint with good stand-off height but no or low fillet will have reduced life
but may meet the application requirement. The first step in achieving good standoff is the solder paste stencil design
for the perimeter pads. The stencil aperture opening should be designed so that maximum paste release is achieved.
This is typically accomplished by considering the following two ratios:
For rectangular aperture openings, as required for this package, these ratios are given as:
Where L and W are the aperture length and width, and T is stencil thickness. For optimum paste release the area and
the aspect ratios should be greater than 0.66 and 1.5 respectively. It is recommended that the stencil aperture should
be 1:1 to the PCB pad sizes as both the area and the aspect ratio targets are easily achieved by this aperture. The
opening can be reduced for a lead pullback option because of the reduction of the solderable area on the package.
The stencil should be laser cut and electro polished. The polishing helps in smoothing the stencil walls which results
in a better paste release. It is also recommended that the stencil aperture tolerances should be tightly controlled,
especially for 0.5mm pitch and finer devices, as these tolerances can effectively reduce the aperture size.
─ Area Ratio
─ Aspect Ratio
─ Area Ratio
─ Aspect Ratio
0.5 mm and Higher Pitch Parts
Stencil Design for Perimeter Pads
=
=
=
=
Area of Aperture Opening / Aperture Wall Area
Aperture width / Stencil Thickness
LW / 2T(L+W)
W / T
Solder Mask
13.56 MHz Type B RF Reader
0.4 mm Pitch Parts
37