pef20550 Infineon Technologies Corporation, pef20550 Datasheet - Page 349

no-image

pef20550

Manufacturer Part Number
pef20550
Description
Extended Line Card Interface Controller Elic
Manufacturer
Infineon Technologies Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
pef20550H
Manufacturer:
FAI
Quantity:
543
PEB 20550
PEF 20550
Application Hints
5.9.2.2 Small PBX
Figure 118 shows a realization example of a small PBX. If the total number of lines
(internal or external) is smaller than the capacity of the ELIC (32
(2
B + D) or 64
B),
the PCM interface of the ELIC need not to be connected to a switching network since all
the B (and D) channel switching can be done inside the ELIC. In this special case, it is
sufficient to apply only a PCM clock to the ELIC, the PCM frame synchronization signal
(8 kHz) can be omitted. The IOM-2 clock and framing signals DCL and FSC are still
generated correctly by the ELIC. The STAR:PSS bit should then not be evaluated: it
stays at logical 0 all the time.
The PBX shown in the figure 118 offers 8 analog (t/r) subscriber lines, realized with two
quadruple codec/filter devices SICOFI-4 (PEB 2465) and one digital, so subscriber
interface realized with the SBCX (PEB2081).
The figure 119 also shows a digital trunk line (external line) which is realized with a U
-
k
layer-1 device, IEC-Q (PEB 2091), operated in NT-PABX mode. The PBX can therefore
be connected directly to the U
interface coming from the CO. The NT-PABX mode of
k
the U
- layer-1 devices is similar to the LT-T mode of the S layer-1 devices: in both cases
k
the layer-1 device delivers a reference clock which is synchronous to the received S or
U
- frame and that can be used to synchronize the local PBX clock generator. Any phase
k
differences between the local IOM-2 frame and the received S or U
- frame are
k
compensated for in an elastic buffer inside the layer-1 devices.
Signaling control for the S
subscriber interface is performed by the ELIC SACCO-A
0
HDLC controller.
Since the digital trunk line also needs a D channel handler, the ELIC SACCO-B HDLC
controller is assigned to that IOM-2 channel.
Semiconductor Group
349
01.96

Related parts for pef20550