mpc8360e Freescale Semiconductor, Inc, mpc8360e Datasheet - Page 86

• Manufacturer Part Number: mpc8360e
• Description: Mpc8360e Powerquicc Ii Pro Family
• Manufacturer: Freescale Semiconductor, Inc

Package and Pin Listings
86
NC
Notes:
1. This pin is an open drain signal. A weak pull-up resistor (1 kΩ) should be placed on this pin to OV
2. This pin is an open drain signal. A weak pull-up resistor (2–10 kΩ) should be placed on this pin to OV
3. This output is actively driven during reset rather than being three-stated during reset.
4. These JTAG pins have weak internal pull-up P-FETs that are always enabled.
5. This pin should have a weak pull up if the chip is in PCI host mode. Follow PCI specifications recommendation.
6. These are On Die Termination pins, used to control DDR2 memories internal termination resistance.
7. This pin must always be tied to GND.
8. This pin must always be left not connected.
9. Refers to MPC8360E PowerQUICC II™ Pro Integrated Communications Processor Reference Manual section on "RGMII
10. This pin must always be tied to GV
11. It is recommended that MDIC0 be tied to GND using an 18.2 Ω resistor and MDIC1 be tied to DDR power using an 18.2 Ω
MPC8360E/MPC8358E PowerQUICC™ II Pro Processor Revision 2.x TBGA Silicon Hardware Specifications, Rev. 2
Pins" for information about the two UCC2 Ethernet interface options.
resistor for DDR2.
Signal
Table 67. MPC8358E TBGA Pinout Listing (continued)
AM16, AM17, AM20, AN13, AN16, AN17, AP10, AP11,
AP13, AP15, AP18, AR11, AR13, AR14, AR15, AR16,
AR17, AR20, AT11, AT12, AT13, AT14, AT16, AT17,
AT18, AU10, AU11, AU12, AU13, AU15, AU19
DD
.
Package Pin Number
Pin Type
DD.
—
Freescale Semiconductor
DD
.
Supply
Power
—
Notes
—