bsv-1.5s12r0h XP Power Limited, bsv-1.5s12r0h Datasheet - Page 28

• Manufacturer Part Number: bsv-1.5s12r0h
• Description: Pol Dc-dc Converter
• Manufacturer: XP Power Limited

Usually BSV-H series is used, adding an input/ output capacitor, please
make sure to design the printed board with special attention to the following
items in order to obtain lower noise level by taking advantage of the
performance of the converter.
1. Use low impedance capacitor with good high frequency characteristic.
2. Shorten the lead of each capacitor as much as possible, and make it
low lead inductance.
3. Make the wiring loop space between the (+) and (-) of both input and
output pin side as small as possible. You can decrease the possibilities of
leakage inductance.
4. Design the printed pattern of the main circuit as thick and short as possible.
- This product is for being used in general electric equipments (business equipments, telecommunication equipments and measurement equipments).
- For this product parallel and series operation are not possible.
- For mounting this product, please do not use connector of socket. The performance may not be fulfilled due to the effect of contacting resistor.
- This product has a built-in over-current, short protection, but long time short circuit will cause failure, so please avoid it.
- There is possibility of damage when used under electric conditions and environmental conditions such as temperature that are out of the standards.
- There is possibility of damage by static. When the worker has electrified static, electrical discharge should be done and the working on the table so
- Do not store in a place where corridible gas may be generated or a dusty place.
- This product does not have a built-in fuse. Connect a fuse to the +input line for protection when over-current flows into input at abnormal. Please
- This product does not have a built-in over-voltage protection. When over-voltage occurs due to the abnormality in the module, there is a mode that
- No test result certificate attached to this product.
5-7-8 Negishi Minami-ku Saitama-shi, Saitama Japan 336-0024
Tel: [phone]
E-mail: [e-mail]
URL http://www.bellnix.co.jp/
All specifications are subject to change without notice.
PRINTED IN JAPAN BDD20080825
<Method to lower the noise (ex.)>
<Precautions>
Bellnix Co., Ltd.
Can not be used in medical equipments, nuclear equipments and trains which would affect lives or properties directly by the failure of this product.
Be sure to contact our sales when using in besides general use.
Mount to print board by soldering.
Be sure to be use within the standards.
grounded may be recommended.
be sure that the supplying power has the capacity to fuse the fuse.
input voltage comes out at it is, and may cause smoke and ignition. To preven this, be sure to add over-voltage protection.
Fax: [phone]
+Vin
Make the loop space small
Make the lead short
+Vin
-Vin
C1
+Vin
BSV-H
GND
series
+Vout
BSV-H Series
Make the loop space small
Make the lead short
C2
+Vout
Load