SB2A-16A Qlogic Corporation, SB2A-16A Datasheet - Page 149

• Manufacturer Part Number: SB2A-16A
• Description: Development Tools, SANbox 16-port Switch
• Manufacturer: Qlogic Corporation

59021-06 A
LIPF7ALPS
LIPF8ALPS
LIPF7F7
LIPF8F7
Link Failures
Login
Logout
LoopTimeouts
LossOfSync
PrimSeqErrors
RxLinkResets
RxOfflineSeq
TotalErrors
TotalLIPsRecvd
TotalLIPsXmitd
TotalLinkResets
TotalOfflineSeq
Entry
Table B-15. Show Port Parameters (Continued)
This LIP is used to reinitialize the loop. An L_Port,
identified by AL_PS, may have noticed a performance
degradation and is trying to restore the loop.
This LIP denotes a loop failure detected by the L_Port
identified by AL_PS.
A loop initialization primitive frame used to acquire a valid
AL_PA.
A loop initialization primitive frame used to indicate that a
loop failure has been detected at the receiver.
Number of optical link failures detected by this port. A link
failure is a loss of synchronization or by loss of signal while
not in the offline state. A loss of signal causes the switch to
attempt to re-establish the link. If the link is not
re-established, a link failure is counted. A link reset is
performed after a link failure.
Number of device logins
Number of device logouts
A two (2) second timeout as specified by FC-AL-2.
Number of synchronization losses (>100 ms) detected by
this port. A loss of synchronization is detected by receipt of
an invalid transmission word.
Primitive sequence errors detected.
Number of link reset primitives received from an attached
device.
Number of offline sequences received. An OLS is issued
for link initialization, a Receive & Recognize
Not_Operational (NOS) state, or to enter the offline state.
Total number of errors detected.
Number of loop initialization primitive frames received by
this port.
Number of loop initialization primitive frames transmitted
by this port.
Total number of link reset primitives.
Total number of Offline Sequences issued by this port.
Description
B – Command Line Interface
Show Command
B-51