SB2A-16A Qlogic Corporation, SB2A-16A Datasheet - Page 141

• Manufacturer Part Number: SB2A-16A
• Description: Development Tools, SANbox 16-port Switch
• Manufacturer: Qlogic Corporation

Set Setup Command
Authority
Syntax
Keywords
59021-06 A
Changes SNMP and system configuration settings. The switch maintains one
SNMP configuration and one system configuration.
Admin
set setup
snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings.
Table B-13
press the Enter key to accept the current value shown in brackets.
Contact
Location
Trap [1-5] Address
Trap [1-5] Port
Trap [1-5] Severity
Trap [1-5] Version
Trap [1-5] Enabled
ReadCommunity
WriteCommunity
snmp
system
Entry
describes the SNMP fields. For each parameter, enter a new value or
Table B-13. SNMP Configuration Settings
Specifies the name of the person to be contacted to respond
to trap events. The default is undefined.
Specifies the name of the switch location. The default is
undefined.
Specifies the workstation IP address to which SNMP traps
are sent. The default address for trap 1 is 10.0.0.254. The
default address for traps 2–5 is 0.0.0.0. Addresses, other
than 0.0.0.0, for all traps must be unique.
Specifies the workstation port to which SNMP traps are sent.
The default is 162.
Specifies the severity level to use when monitoring trap
events. The default is Warning
Specifies the SNMP version (1 or 2) to use in formatting
traps. The default is 2.
Specifies whether traps (event information) are enabled or
disabled (default).
Read community password that authorizes an SNMP agent
to read information from the switch. This is a write-only field.
The value on the switch and the SNMP management server
must be the same. The default is “public”.
Write community password that authorizes an SNMP agent
to write information to the switch. This is a write-only field.
The value on the switch and the SNMP management server
must be the same. The default is “private”.
Description
B – Command Line Interface
Set Setup Command
B-43