SB2A-16A Qlogic Corporation, SB2A-16A Datasheet - Page 143

• Manufacturer Part Number: SB2A-16A
• Description: Development Tools, SANbox 16-port Switch
• Manufacturer: Qlogic Corporation

Examples
59021-06 A
The following is an example of the Set Setup SNMP command:
SANbox2 #> admin start
SANbox2 (admin) #> set setup snmp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Trap Severity Options
---------------------
unknown, emergency, alert, critical, error, warning, notify, info, debug, mark
AdminTimeout
TempMonitoringWarning
TempMonitoringFailure
TempFailurePortShutdown
SecurityEnabled
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
Table B-14. System Configuration Settings (Continued)
Entry
Specifies the amount of time in minutes the switch
waits before terminating an idle Admin session.
Zero (0) disables the time out threshold. The
default is 30, the maximum is 1440.
Warning temperature threshold in °C above which
a warning condition alarm is generated. The
default is 65 °C.
Failure temperature threshold in °C above which a
failure condition alarm is generated. The default is
70 °C.
Enables (True) or disables (False) the switch’s
ability to place all ports down when the internal
temperature exceeds the failure threshold. The
default is False.
Enables (True) or disables (False) the enforcement
of account names and passwords. The default is
False.
Enables (True) or disables (False) the saving of log
information on the switch. The default is True.
Enables (True) or disables (False) the recording of
the switch event log on a remote host that supports
the syslog protocol. The default is False.
The IP address of the host that will receive the
switch event log information if remote logging is
enabled. The default is 10.0.0.254.
Description
B – Command Line Interface
Set Setup Command
B-45