LM3S6911 Luminary Micro, Inc, LM3S6911 Datasheet - Page 25

• Manufacturer Part Number: LM3S6911
• Description: Lm3s6911 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

July 26, 2008
■
■
■
■
–
–
ARM FiRM-compliant Watchdog Timer
–
–
–
–
–
–
10/100 Ethernet Controller
–
–
–
–
–
–
Synchronous Serial Interface (SSI)
–
–
–
–
–
–
–
UART
16-bit Input Capture modes
•
•
16-bit PWM mode
•
32-bit down counter with a programmable load register
Separate watchdog clock with an enable
Programmable interrupt generation logic with interrupt masking
Lock register protection from runaway software
Reset generation logic with an enable/disable
User-enabled stalling when the controller asserts the CPU Halt flag during debug
Conforms to the IEEE 802.3-2002 Specification
Full- and half-duplex for both 100 Mbps and 10 Mbps operation
Integrated 10/100 Mbps Transceiver (PHY)
Automatic MDI/MDI-X cross-over correction
Programmable MAC address
Power-saving and power-down modes
Two SSI modules, each with the following features:
Master or slave operation
Programmable clock bit rate and prescale
Separate transmit and receive FIFOs, 16 bits wide, 8 locations deep
Programmable interface operation for Freescale SPI, MICROWIRE, or Texas Instruments
synchronous serial interfaces
Programmable data frame size from 4 to 16 bits
Internal loopback test mode for diagnostic/debug testing
Input edge count capture
Input edge time capture
Simple PWM mode with software-programmable output inversion of the PWM signal
Preliminary
LM3S6911 Microcontroller
25