DSP-A1092 ETC, DSP-A1092 Datasheet - Page 27

• Manufacturer Part Number: DSP-A1092
• Description: NATURAL SOUND AV AMPLIFIRE
• Manufacturer: ETC

For connecting with a monitor TV that uses a 21 pin
connector for input (for Europe and U.K. models)
available scart-plug connector cable.
Monitor TV
Make a connection as figured below with a commercially
PAL NTSC
Scart-plug
connector
cable
MONITOR
VCR 2
OUT
OUT
IN
No connection
MONITOR
VCR 2
OUT
OUT
IN
CONNECTING SPEAKER SYSTEMS
of the proper gauge, cut as short as possible. If the connections
are faulty, no sound will be heard from the speakers. Make sure
that the polarity of the speaker wires is correct, that is, + and –
markings are observed. If these wires are reversed, the sound will
be unnatural and will lack bass. Do not let the bare speaker wires
touch each other or any other metal part as this could damage this
unit and/or speakers.
NOTE: Use speakers with the specified impedance shown on the
rear of this unit.
NOTE: Banana Plug connections are also possible (Australia and
General models only). Simply insert the Banana Plug connector
into the corresponding terminal.
Connect the SPEAKERS terminals to your speakers with wire
1
2
3
Red: positive (+)
Black: negative (–)
Unscrew the knob.
Insert the bare wire.
[Remove approx. 5mm (1/4”)
insulation from the speaker
wires.]
Tighten the knob and
secure the wire.
25