T546HW01-V1 AUO, T546HW01-V1 Datasheet - Page 30

• Manufacturer Part Number: T546HW01-V1
• Description: LCD Module
• Manufacturer: AUO

9. Precautions
8-1 MOUNTING PRECAUTIONS
(1) You must mount a module using holes arranged on back side of panel
(2) You should consider the mounting structure so that uneven force (ex. Twisted stress) is not applied to
(3) Please attach the surface transparent protective plate to the surface in order to protect the polarizer.
(4) You should adopt radiation structure to satisfy the temperature specification.
(5) Acetic acid type and chlorine type materials for the cover case are not desirable because the former
(6) Do not touch, push or rub the exposed polarizers with glass, tweezers or anything harder than HB pencil
(7) When the surface becomes dusty, please wipe gently with absorbent cotton or other soft materials like
(8) Wipe off saliva or water drops as soon as possible. Their long time contact with polarizer causes
(9) Do not open the case because inside circuits do not have sufficient strength.
8-2 OPERATING PRECAUTIONS
(1) The spike noise causes the mis-operation of circuits. It should be lower than following voltage:
(2) Response time depends on the temperature. (In lower temperature, it becomes longer.)
(3) Brightness depends on the temperature. (In lower temperature, it becomes lower.) And in lower temperature,
(4) Be careful for condensation at sudden temperature change. Condensation makes damage to polarizer or
(5) When fixed patterns are displayed for a long time, remnant image is likely to occur.
(6) Module has high frequency circuits. Sufficient suppression to the electromagnetic interference shall be done
(7) The device listed in the product specification sheets was designed and manufactured for TV application.
©Copyright AU Optronics Corp.
2009 All Rights Reserved.
No Reproduction and Redistribution Allowed
Please pay attention to the followings when you use this TFT LCD module.
module. And the case on which a module is mounted should have sufficient strength so that external force is
not transmitted directly to the module.
Transparent protective plate should have sufficient strength in order to the resist external force.
generates corrosive gas of attacking the polarizer at high temperature and the latter causes circuit break by
electro-chemical reaction.
lead. And please do not rub with dust clothes with chemical treatment. Do not touch the surface of polarizer
for bare hand or greasy cloth. (Some cosmetics are detrimental to the polarizer.)
chamois soaks with petroleum benzene. Normal-hexane is recommended for cleaning the adhesives used
to attach front/ rear polarizers. Do not use acetone, toluene and alcohol because they cause chemical
damage to the polarizer.
deformations and color fading.
V=
response time (required time that brightness is stable after turned on) becomes longer.
electrical contacted parts. And after fading condensation, smear or spot will occur.
by system manufacturers. Grounding and shielding methods may be important to minimize the interface.
±
2 00mV (Over and under shoot voltage)
T546HW01 V1
www.DataSheet.co.kr
30/31
Datasheet pdf - http://www.DataSheet4U.net/