SST55LD019A Silicon Storage Technology, Inc., SST55LD019A Datasheet - Page 52

no-image

SST55LD019A

Manufacturer Part Number
SST55LD019A
Description
Ata Flash Disk Controllersst's Ata Flash Disk Controller is The Heart of a High Performance, Flash Media-based Data Storage System. The Ata Flash Disk Controller Recognizes The Control, Address, And Data Signals on The Ata/ide Bus And Translates Them
Manufacturer
Silicon Storage Technology, Inc.
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
SST55LD019A
Manufacturer:
SST
Quantity:
5 510
Part Number:
SST55LD019A
Manufacturer:
NS
Quantity:
5 510
Part Number:
SST55LD019A-45-C-BWE
Manufacturer:
SST
Quantity:
2 294
Part Number:
SST55LD019A-45-C-T
Manufacturer:
SST
Quantity:
20 000
Part Number:
SST55LD019A-45-C-TQWE
Manufacturer:
INFINEON
Quantity:
4 300
Part Number:
SST55LD019A-45-I-BWE
Manufacturer:
ST
Quantity:
212
Advance Information
11.2.1.29 Set-Multiple-Mode - C6H
11.2.1.30 Set-Sleep-Mode - 99H or E6H
©2004 Silicon Storage Technology, Inc.
Command (7)
Command (7)
This command enables the ATA Flash Disk Controller to perform Read and Write-Multiple operations
and establishes the block count for these commands. The Sector Count register is loaded with the
number of sectors per block. Upon receipt of the command, the ATA Flash Disk Controller sets BSY to 1
and checks the Sector Count register.
If the Sector Count register contains a valid value (see Section 11.2.1.6.12 for details) and the block
count is supported, the value is loaded for all subsequent Read-Multiple and Write-Multiple commands
and execution of those commands is enabled. If a block count is not supported, an Aborted Command
error is posted, and Read-Multiple and Write-Multiple commands are disabled. If the Sector Count
register contains 0 when the command is issued, Read and Write-Multiple commands are disabled. At
power on, or after a hardware or (unless disabled by a Set Feature command) software reset, the
default mode is Read and Write-Multiple disabled.
This command causes the ATA Flash Disk Controller to set BSY, enter the Sleep mode, clear BSY and
generate an interrupt. Recovery from sleep mode is accomplished by simply issuing another command
(a reset is permitted but not required). Sleep mode is also entered when internal timers expire so the
host does not need to issue this command except when it wishes to enter Sleep mode immediately. The
default value for the timer is 15 milliseconds.
Sec Num (3)
Sec Num (3)
Cyl High (5)
Cyl High (5)
Cyl Low (4)
Cyl Low (4)
Sec Cnt (2)
Sec Cnt (2)
Feature (1)
Feature (1)
C/D/H (6)
C/D/H (6)
Bit ->
Bit ->
7
7
X
X
6
6
SST55LD019A / SST55LD019B / SST55LD019C
5
5
52
Drive
Drive
4
4
Sector Count
99H or E6H
C6H
X
X
X
X
X
X
X
X
X
3
3
ATA Flash Disk Controller
2
2
X
X
1
1
S71241-02-000
0
0
4/04

Related parts for SST55LD019A