ATA6602 ATMEL Corporation, ATA6602 Datasheet - Page 86

• Manufacturer Part Number: ATA6602
• Description: LIN and Microcontroller System-In-Package: LIN Transceiver, integrated 5V/50 mA voltage regulator, window watchdog and automotive AVR ATmega88 (8 kBytes Flash); green QFN48 package.
• Manufacturer: ATMEL Corporation

86
ATA6602/ATA6603
Figure 4-22. I/O Pin Equivalent Schematic
All registers and bit references in this section are written in general form. A lower case “x” repre-
sents the numbering letter for the port, and a lower case “n” represents the bit number. However,
when using the register or bit defines in a program, the precise form must be used. For example,
PORTB3 for bit no. 3 in Port B, here documented generally as PORTxn. The physical I/O Regis-
ters and bit locations are listed in
Three I/O memory address locations are allocated for each port, one each for the Data Register
– PORTx, Data Direction Register – DDRx, and the Port Input Pins – PINx. The Port Input Pins
I/O location is read only, while the Data Register and the Data Direction Register are read/write.
However, writing a logic one to a bit in the PINx Register, will result in a toggle in the correspond-
ing bit in the Data Register. In addition, the Pull-up Disable – PUD bit in MCUCR disables the
pull-up function for all pins in all ports when set.
Using the I/O port as General Digital I/O is described in
87. Most port pins are multiplexed with alternate functions for the peripheral features on the
device. How each alternate function interferes with the port pin is described in
Functions” on page
nate functions.
Note that enabling the alternate function of some of the port pins does not affect the use of the
other pins in the port as general digital I/O.
92. Refer to the individual module sections for a full description of the alter-
Pxn
“Register Description for I/O Ports” on page
C
pin
"General Digital I/O" for
“Ports as General Digital I/O” on page
See Figure
R
pu
Details
Logic
104.
“Alternate Port
4921C–AUTO–01/07