M25PX64-STVME6E Numonyx, B.V., M25PX64-STVME6E Datasheet - Page 53
![no-image](/images/no-image-200.jpg)
M25PX64-STVME6E
Manufacturer Part Number
M25PX64-STVME6E
Description
64-Mbit, dual I/O, 4-Kbyte subsector erase, serial flash memory with 75 MHz SPI bus interface
Manufacturer
Numonyx, B.V.
Datasheet
1.M25PX64-STVME6E.pdf
(66 pages)
M25PX64
7
Power-up and power-down
At power-up and power-down, the device must not be selected (that is Chip Select (S) must
follow the voltage applied on V
A safe configuration is provided in
To avoid data corruption and inadvertent write operations during power-up, a power on reset
(POR) circuit is included. The logic inside the device is held reset while V
power on reset (POR) threshold voltage, V
does not respond to any instruction.
Moreover, the device ignores all write enable (WREN), page program (PP), dual input fast
program (DIFP), program OTP (POTP), subsector erase (SSE), sector erase (SE), bulk
erase (BE), write status register (WRSR) and write to lock register (WRLR) instructions until
a time delay of t
However, the correct operation of the device is not guaranteed if, by this time, V
below V
the later of:
These values are specified in
If the time, t
read instructions even if the t
After power-up, the device is in the following state:
Normal precautions must be taken for supply line decoupling, to stabilize the V
Each device in a system should have the V
the package pins (generally, this capacitor is of the order of 100 nF).
At power-down, when V
(POR) threshold voltage, V
to any instruction (the designer needs to be aware that if power-down occurs while a write,
program or erase cycle is in progress, some data corruption may result).
V
V
t
t
The device is in the standby power mode (not the deep power-down mode)
The write enable latch (WEL) bit is reset
The write in progress (WIP) bit is reset
The lock registers are configured as: (write lock bit, lock down bit) = (0,0).
V
voltage range.
PUW
VSL
CC
SS
PPH
CC
(min) at power-up, and then for a further delay of t
at power-down.
after V
after V
(min). No write status register, program or erase instructions should be sent until
must be applied only when V
VSL
, has elapsed, after V
PUW
CC
CC
has passed the V
has passed the V
has elapsed after the moment that V
CC
WI
drops from the operating voltage, to below the power on reset
PUW
, all operations are disabled and the device does not respond
Table
CC
) until V
delay has not yet fully elapsed.
Section 3: SPI
11.
CC
CC
WI
rises above V
(min) level.
CC
threshold
CC
CC
WI
is stable and in the V
reaches the correct value:
– all operations are disabled, and the device
line decoupled by a suitable capacitor close to
modes.
CC
(min), the device can be selected for
CC
VSL
rises above the V
Power-up and power-down
CC
(min) to V
CC
is less than the
CC
WI
CC
(max)
CC
threshold.
supply.
is still
53/66