STM8S903K3 STMicroelectronics, STM8S903K3 Datasheet - Page 51

• Manufacturer Part Number: STM8S903K3
• Description: 16 MHz STM8S 8-bit MCU, up to 8 Kbytes Flash, 1 Kbyte RAM, 640 bytes EEPROM
• Manufacturer: STMicroelectronics

Specifications of STM8S903K3

• Program Memory: 8 Kbytes Flash; data retention 20 years at 55 °C after 10 kcycles
• Data Memory: 640 bytes true data EEPROM; endurance 300 kcycles
• Ram: 1 Kbytes
• Advanced Control Timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, dead-time insertion and flexible synchronization

STM8S903K3 STM8S903F3
10
10.1
10.1.1
10.1.2
10.1.3
10.1.4
10.1.5
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100 % of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on characterization,
the minimum and maximum values refer to sample tests and represent the mean value plus
or minus three times the standard deviation (mean ± 3 Σ).
Typical values
Unless otherwise specified, typical data are based on T
only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean ± 2 Σ).
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are not
tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in the following figure.
Pin input voltage
The input voltage measurement on a pin of the device is described in the following figure.
Figure 8: Pin loading conditions
DocID15590 Rev 6
50 pF
STM8 pin
A
A
SS
= 25 °C and T
= 25 °C, V
.
Electrical characteristics
DD
= 5 V. They are given
A
= T
Amax
(given by
51/115