M40800 Atmel Corporation, M40800 Datasheet - Page 239

• Manufacturer Part Number: M40800
• Manufacturer: Atmel Corporation

Specifications of M40800

• Flash (kbytes): 0 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 40 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 32
• Ext Interrupts: 32
• Usb Speed: No
• Usb Interface: No
• Uart: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 8
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: No
• Calibrated Rc Oscillator: No

ARM DDI 0029G
The following scan chain control signals can also be used for scan chain 3:
nHIGHZ
RSTCLKBS This signal is active when the TAP controller state machine is in the
In addition to these control outputs, SDINBS output and SDOUTBS input are also
provided. When an external scan chain is in use, SDOUTBS must be connected to the
serial data output of the external scan chain and SDINBS must be connected to the serial
data input of the scan chain.
Copyright © 1994-2001. All rights reserved.
This signal can be used to drive the outputs of the scan cells to the HIGH
impedance state. This signal is driven LOW when the HIGHZ instruction
is loaded into the instruction register and HIGH at all other times.
RESET-TEST LOGIC state. It can be used to reset any additional scan
cells.
Debug in Depth
B-21