AT83C5136 Atmel Corporation, AT83C5136 Datasheet - Page 108

• Manufacturer Part Number: AT83C5136
• Manufacturer: Atmel Corporation

Specifications of AT83C5136

• Max. Operating Frequency: 32 MHz
• Cpu: 8051-12C
• Max I/o Pins: 34
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 1
• Uart: 1
• Sram (kbytes): 1.25
• Eeprom (bytes): 512
• Operating Voltage (vcc): 2.7 to 3.6
• Timers: 4
• Mask Rom (kbytes): 32
• Watchdog: Yes

21.4.2
108
AT83C5134/35/36
Bulk/Interrupt OUT Transactions in Ping-pong Mode
Figure 21-8. Bulk/Interrupt OUT Transactions in Ping-pong Mode
An endpoint will be first enabled and configured before being able to receive Bulk or Interrupt
packets.
When a valid OUT packet is received on the endpoint bank 0, the RXOUTB0 bit is set by the
USB controller. This triggers an interrupt if enabled. The firmware has to select the correspond-
ing endpoint, store the number of data bytes by reading the UBYCTLX and UBYCTHX registers.
If the received packet is a ZLP (Zero Length Packet), the UBYCTLX and UBYCTHX register val-
ues are equal to 0 and no data has to be read.
When all the endpoint FIFO bytes have been read, the firmware will clear the RXOUB0 bit to
allow the USB controller to accept the next OUT packet on the endpoint bank 0. This action
switches the endpoint bank 0 and 1. Until the RXOUTB0 bit has been cleared by the firmware,
the USB controller will answer a NAK handshake for each OUT requests on the bank 0 endpoint
FIFO.
When a new valid OUT packet is received on the endpoint bank 1, the RXOUTB1 bit is set by
the USB controller. This triggers an interrupt if enabled. The firmware empties the bank 1 end-
point FIFO before clearing the RXOUTB1 bit. Until the RXOUTB1 bit has been cleared by the
firmware, the USB controller will answer a NAK handshake for each OUT requests on the bank 1
endpoint FIFO.
The RXOUTB0 and RXOUTB1 bits are alternatively set by the USB controller at each new valid
packet receipt.
The firmware has to clear one of these two bits after having read all the data FIFO to allow a new
valid packet to be stored in the corresponding bank.
OUT
OUT
OUT
HOST
DATA0 (n Bytes)
DATA1 (m Bytes)
DATA0 (p Bytes)
ACK
ACK
ACK
UFI
RXOUTB0
RXOUTB1
RXOUTB0
Endpoint FIFO Bank 0 - Read Byte 1
Endpoint FIFO Bank 0 - Read Byte 2
Endpoint FIFO Bank 0 - Read Byte n
Endpoint FIFO Bank 1 - Read Byte 1
Endpoint FIFO Bank 1 - Read Byte 2
Endpoint FIFO Bank 1 - Read Byte m
Endpoint FIFO Bank 0 - Read Byte 1
Endpoint FIFO Bank 0 - Read Byte 2
Endpoint FIFO Bank 0 - Read Byte p
Clear RXOUTB0
Clear RXOUTB1
Clear RXOUTB0
C51
7683C–USB–11/07