PTC-04-DB-CALIB Melexis Inc, PTC-04-DB-CALIB Datasheet - Page 8

• Manufacturer Part Number: PTC-04-DB-CALIB
• Description: DUAGHTER BOARD CALIBRATION
• Manufacturer: Melexis Inc
• Series: -r

Specifications of PTC-04-DB-CALIB

• Accessory Type: Calibration Software
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: PTC Programmer

Manual voltmeter
If the Keithley 2000 or Agilent 34401A multimeter feature is not selected the program will ask you to put in
a few values from your voltmeter manually. These are used to calibrate the first sensing line of the PTC-
04. This sensing line will be used as reference meter for the calibration check.
Note: the accuracy of the calibration depends on the precision of the voltmeter and the number of digits
you enter.
For the calibration of the internal reference meter, two series of 32 values are required. Once the internal
reference meter is calibrated the software will continue with the calibration check.
Note: the decimal separator of the software is “.” not “,”. If one uses a “,” as decimal separator, the
calculated parameters will be incorrect.
Note: If you entered a wrong value, press Cancel. Two error messages are shown.
Figure 11: Check Measuring line 1 Failed
Now the calibration check is terminated, you can restart the calibration check.
User manual calibration software PTC04
UI_0PTC04AAMLX Rev. 1.35
•
•
•
Press OK to continue.
Insert the value from the voltmeter in volt [V] and press OK.
Press OK on both messages to continue.
Figure 9: Manual calibration internal reference meter.
Calibration Software PTC04
Figure 10: Input Box Manual Voltmeter.
Page 8 of 17
Figure 12: The calibration check has been cancelled.
User Manual
February 10