LAN9118-MT SMSC, LAN9118-MT Datasheet - Page 18

• Manufacturer Part Number: LAN9118-MT
• Description: IC ETHERNET CTRLR 10/100 100TQFP
• Manufacturer: SMSC
• Type: Single Chip MAC and PHYr

Specifications of LAN9118-MT

• Controller Type: Ethernet Controller
• Interface: Serial EEPROM
• Voltage - Supply: 3.3V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 100-TQFP, 100-VQFP
• Product: Ethernet Controllers
• Number Of Transceivers: 1
• Standard Supported: IEEE 802.3 or IEEE 802.3u
• Data Rate: 10 Mbps or 100 Mbps
• Supply Voltage (max): 3.3 V
• Supply Voltage (min): 0 V
• Maximum Operating Temperature: + 70 C
• Ethernet Connection Type: 100BASE-TX or 10BASE-T
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1013

Revision 1.5 (07-11-08)
PIN
NO.
71,73,
75,84,
90,91
70
74
NAME
Wakeup Indicator
10/100 Selector
Reserved
Table 2.5 System and Power Signals (continued)
SYMBOL
SPEED_SEL
Reserved
PME
DATASHEET
BUFFER
TYPE
O8/OD8
I (PU)
18
High Performance Single-Chip 10/100 Non-PCI Ethernet Controller
NUM
PINS
1
5
1
DESCRIPTION
When programmed to do so, is
asserted when the LAN9118 detects
a wake event and is requesting the
system to wake up from the
associated sleep state. The polarity
and buffer type of this signal is
programmable.
Note:
No Connect
This signal functions as a
configuration input on power-up and
is used to select the default Ethernet
settings. Upon deassertion of reset,
the value of the input is latched. This
signal functions as shown in
Table 2.2, "Default Ethernet
below.
Detection of a Power
Management Event, and
assertion of the PME signal
will not wakeup the
LAN9118. The LAN9118 will
only wake up when it
detects a host write cycle
(assertion of nCS and
nWR). Although any write to
the LAN9118, regardless of
the data written, will wake-
up the device when it is in a
power-saving mode, it is
required that the
BYTE_TEST register be
used for this purpose.
SMSC LAN9118
Settings",
Datasheet