20-101-1112 Rabbit Semiconductor, 20-101-1112 Datasheet - Page 41

• Manufacturer Part Number: 20-101-1112
• Description: MODULE RABBITCORE RCM4010
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1112

• Module/board Type: MPU Core Module
• Product: Microcontroller Modules
• Core Processor: Rabbit 4000
• Clock Speed: 58.98 MHz
• Interface Type: Ethernet, Serial
• Flash: 512 KB
• Timers: 10 x 8 bit, 1 x 10 bit, 1 x 16 bit
• Operating Supply Voltage: 3 V to 3.6 V
• Board Size: 47 mm x 61 mm x 20 mm
• Core: RCM4010
• Processor Series: RCM4000
• Silicon Manufacturer: Rabbit
• Core Architecture: Rabbit 4000
• Silicon Core Number: RCM4010
• Silicon Family Name: RCM4000
• Kit Contents: Board
• Development Tool Type: Hardware / Software - Dev Kit (Dev Tool)
• Rohs Compliant: Yes
• For Use With/related Products: RCM4010
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q3413688

Table 3 summarizes the possible parallel port pins for the serial ports and their clocks.
4.2.1.1 Using the Serial Ports
The receive lines on the RCM4000 serial ports do not have pull-up resistors. If you are
using the serial ports without a receiver chip (for example, for RS-422, RS-232, or RS-485
serial communication), the absence of a pull-up resistor on the receive line will likely lead
to line breaks being generated since line breaks are normally generated whenever the
receive line is pulled low. If you are operating a serial port asynchronously, you can inhibit
character assembly during breaks by setting bit 1 in the corresponding Serial Port
Extended Register to 1. Should you need line breaks, you will have to either add a pull-up
resistor on your motherboard or use a receiver that incorporates the circuits to have the
output default to the nonbreak levels.
The Dynamic C
NOCHARASSYINBRK
This macro is already defined so that it is the default behavior for the sample programs in
the Dynamic C
User’s Manual
Serial Port A
Serial Port B
(RCM4010
only)
Serial Port C
RCLKF must be selected to be on the same parallel port as TXF.
#define RS232_NOCHARASSYINBRK
SCLKA
SCLKB
SCLKC
SAMPLES\RCM4000\SERIAL
RS232.LIB
RXA
TXA
TXB
RXB
TXC
RXC
Table 3. Rabbit 4000 Serial Port and Clock Pins
to inhibit break-character assembly for all the serial ports.
PC6, PC7
PC7, PE7
PB1
PC4, PC5
PC5, PE5
PB0
PC2, PC3
PC3, PE3
PE2, PE7, PC7
library requires you to define the macro
Serial Port D
Serial Port F
folder.
SCLKD
RCLKF
TCLKF
RXD
TXD
TXF
RXF
RS232_
PC0, PC1
PC1, PE1
PE0, PE3, PC3
PE2, PC2
PE3, PC3
PE1, PC1
PE0, PC0
35