ICS9248BF-96 IDT, Integrated Device Technology Inc, ICS9248BF-96 Datasheet - Page 7

• Manufacturer Part Number: ICS9248BF-96
• Description: IC FREQ GENERATOR/BUFFER 48-SSOP
• Manufacturer: IDT, Integrated Device Technology Inc
• Type: Frequency Generatorr

Specifications of ICS9248BF-96

• Input: Crystal
• Output: Clock
• Frequency - Max: 166.5MHz
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 48-SSOP
• Frequency-max: 166.5MHz
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 9248BF-96

The power down selection is used to put the part into a very low power state without turning off the power to the part.
PD# is an asynchronous active low input. This signal needs to be synchronized internal to the device prior to powering
down the clock synthesizer.
Internal clocks are not running after the device is put in power down. When PD# is active low, all clocks need to be
driven to a low value and held prior to turning off the VCOs and crystal. The power up latency needs to be less than
3 ms. The power down latency should be as short as possible but conforming to the sequence requirements shown
below. The REF and 48MHz clocks are expected to be stopped in the LOW state as soon as possible. Due to the state
of the internal logic, stopping and holding the REF clock outputs in the LOW state may require more than one clock
cycle to complete.
PD# Timing Diagram
Notes:
1. All timing is referenced to the Internal CPUCLK (defined as inside the ICS9248 device).
2. As shown, the outputs Stop Low on the next falling edge after PD# goes low.
3. PD# is an asynchronous input and metastable conditions may exist. This signal is synchronized inside this part.
4. The shaded sections on the VCO and the Crystal signals indicate an active clock.
5. Diagrams shown with respect to 133MHz. Similar operation when CPU is 100MHz.
0311D—04/23/04
7
ICS9248-96