Z6S248C STEC, Z6S248C Datasheet - Page 95

• Manufacturer Part Number: Z6S248C
• Manufacturer: STEC
• Type: Solid State Driver

Specifications of Z6S248C

• Density: 48GByte
• Operating Supply Voltage (typ): 5V
• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Package Type: Not Required
• Mounting: Screw
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 4.75V
• Operating Supply Voltage (max): 5.25V
• Lead Free Status / RoHS Status: Compliant

FCC Declaration of Conformity
Limited Warranty
Modifications
STEC Inc. (“STEC”) SATA Solid State Drives (“SSD”) are warranted against defects in material and workmanship, and
will operate in substantial conformance with their respective specifications under normal use and service for a period of
five (5) years from the date of shipment. Subject to the conditions and limitations set forth below, STEC will, at its own
option, either repair or replace any defective SSD Product that proves to be defective by reasons of improper
workmanship or materials, if buyer notifies STEC of such failure within the stated warranty period. Products repaired or
replaced during the applicable warranty period shall be covered by the foregoing warranties for the remainder of the
original warranty period or ninety (90) days from the date of reshipment, whichever is longer. Parts used to repair
products or replacement products may be provided by STEC on an exchange basis, and will be either new or refurbished
to be functionally equivalent to new.
STEC DISCLAIMS ALL OTHER WARRANTIES, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT
LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
WITH RESPECT TO ITS PRODUCTS AND ANY ACCOMPANYING WRITTEN MATERIALS. FURTHER, STEC
DOES NOT WARRANT THAT SOFTWARE WILL BE FREE FROM DEFECTS OR THAT ITS USE WILL BE
UNINTERRUPTED OR REGARDING THE USE, OR THE RESULTS OF THE USE OF THE SOFTWARE IN TERMS
OF CORRECTNESS, ACCURACY, RELIABILITY OR OTHERWISE.
STEC is not responsible for updates or functionality of third-party software. Software is provided with notices and/or
licenses from third parties which govern your use.
Any changes or modifications made to this device that are not expressly approved by STEC will void the user’s warranty.
All wiring external to the product should follow the provisions of the current edition of the National Electrical Code.
The Zeus SATA Solid State Drive carries the FCC-Mark in accordance with related Federal
Communications Commission (FCC)–USA directives. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Modifications made to this device that are not approved by STEC may void the authority granted to the user
by the FCC to operate this equipment.
•
•
•
•
•
•
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/television technician for help.
C
ERTIFICATION AND
W
ARRANTY
77