Z6S248C STEC, Z6S248C Datasheet - Page 34

• Manufacturer Part Number: Z6S248C
• Manufacturer: STEC
• Type: Solid State Driver

Specifications of Z6S248C

• Density: 48GByte
• Operating Supply Voltage (typ): 5V
• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Package Type: Not Required
• Mounting: Screw
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 4.75V
• Operating Supply Voltage (max): 5.25V
• Lead Free Status / RoHS Status: Compliant

16
Functional Blocks
The Zeus SATA SSDs comprise the following primary functional component blocks:
SATA Interface Block
This section provides information on the SATA connector of the Zeus SSD.
SATA Interface Connector
The connector on Zeus SATA SSDs is divided into a Signal Segment (S1 - S7) and a Power Segment
(P1 - P15). The connector supports the signal and power segments cabled up to 1 meter (39 inches)
and backplane connections. The connector is designed to blind mate, has staggered contacts to
facilitate “hot plugging”, and supports the future 3.0 Gb/sec speed. See Figure 2.
Signal Segment Pinout Configuration
A SATA signal cable uses a protocol transmitted over a 7-pin cable, versus the current IDE 40/80
conductor cable. Figure 2 identifies the 7-pin signal segment of the cable. Table 6 lists the signal
definitions of the 7-pin segment.
•
•
•
SATA Interface Block
SSD Control Block
NAND Flash Memory
Figure 2.
SATA Signal Segment
Zeus 2.5-Inch Serial ATA Solid State Drive