SRCS14L Intel (CPU), SRCS14L Datasheet - Page 13

• Manufacturer Part Number: SRCS14L
• Manufacturer: Intel (CPU)

Specifications of SRCS14L

• Lead Free Status / RoHS Status: Supplier Unconfirmed

2.3
2.4
2.5
2.6
Technical Product Specification
Table 5. Hardware Architecture
Table 6. Electrical Specifications
Table 7. Environmental Test Results
Architecture Features (HW)
Electrical Characteristics
Environmental Specifications
Supported Hard Drive Technology
The RAID controller supports up to 4 hard disk drives connected to the 4 SATA ports. These hard
drives must be compliant with the SATA specification 1.0.
Form Factor (physical dimensions)
Voltage Requirements
Power Consumption
I/O Microprocessor
I/O interface (PCI)
PCI Transfer Rate
Environmental Stress Test
SATA controllers
Cache Memory
Flash Memory
PCI Signaling
Component
Operating Temperature
Storage Temperature
Attribute
The 80303 processor: 100MHz, RISC 64-bit core
3.3V unbuffered, PC100, ECC SDRAM. 64MB embedded not upgradeable
3.3v, 32Mb (4MB) flash memory chip is used to store the RAID firmware
PCI 2.2 compliant, universally keyed for 3.3 and 5 volt PCI slots
528 MB/sec (Burst) DMA to PCI and local buses
+5 or +3.3 volt
Two Silicon Image Sil3112A SATA controllers, which each control two serial
ports (four ports total) with speeds up to 1.5 Gbps
0° C to +55° C
-40° C to +70° C
Height: 56mm
Length: 167mm
+3.3 or +5 Volts (all +/– 5% tolerance)
Intel® Integrated RAID Controller SRCS14L
+3.3 Volts @ 2.5 Amps = 8.25W
+5 Volts @ 0.25 Amps = 1.25W
Meets Required Conditions
Measurements
Features
13