2-830613-2 TE Connectivity, 2-830613-2 Datasheet - Page 5

• Manufacturer Part Number: 2-830613-2
• Description: Cable Assembly Lead 0.3556m 16AWG LGH
• Manufacturer: TE Connectivity

Specifications of 2-830613-2

• Connector Type: LGH
• Cable Type: Lead
• Cable Length: 0.356 m
• Product Type: Lead Assembly
• Mount Angle: Straight
• Cap Material: Glass-Filled Epoxy
• Wire Size (mm² [awg]): 16
• Operating Voltage (kvdc): 15
• Shielded: No
• Lead Assembly Type: Single-End
• Assembly Length (mm [in]): 355.60 [14.000]
• Barrel Depth (mm [in]): 22.61 [0.890]
• Positive Stop Ferrule: Without
• Wire Color: White (Standard)
• Cap Color: Green
• Pigtail Length (mm [in]): 9.65 [0.380]
• Wire Diameter (mm [in]): 4.22 [0.166]
• Wire Insulation: Silicone
• Preloaded: Yes
• Rohs/elv Compliance: ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was ELV compliant

4.
4.1.
4.2.
4.3.
4.4.
Rev O2
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to the product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product m eets the requirem ents of Figure 1. Failures
attributed to equipm ent, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specim ens resubm itted for qualification. Testing to
confirm corrective action is required before resubm ittal.
Quality Conform ance Inspection
The applicable quality inspection plan shall specify the sam pling acceptable quality level to be used.
Dim ensional and functional requirem ents shall be in accordance with the applicable product drawing
and this specification.
Specim en Selection
Specim ens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Test group 1 shall consist of 28 lead assem blies and
receptacles; 4 each from 1/2I, 1/2LI, LI, 1LI, 2I, 3I and 4I series. Test group 2 shall consist of 14
herm etic seal type receptacles; 2 each from 1/2I, 1/2LI, LI, 1LI, 2I, 3I and 4I series.
Test Sequence
Qualification inspection shall be verified by testing specim ens as specified in Figure 2.
108-36033
5 of 6