NT631C-ST153-EV3 Omron, NT631C-ST153-EV3 Datasheet - Page 58

• Manufacturer Part Number: NT631C-ST153-EV3
• Description: 10.48-ColrDisplay,TFT,Ivy,Eng
• Manufacturer: Omron

Specifications of NT631C-ST153-EV3

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Writing Screen Data to a
Memory Unit Using
Automatic Transmission
(PT to Memory Unit)
Using a Memory Unit
Reference:
Reference:
SW2
*: The Memory Unit stores system program or screen data for one PT in each
In this mode, system program or the screen data in the NT631/NT631C is
forcibly written to the Memory Unit irrespective of the setting status of the
NT631/NT631C.
This mode is convenient if the touch panel is broken and touch switch opera-
tion is not possible, or if someone unfamiliar with touch switch operation at the
operation site is using the system.
When screen data is written to the Memory Unit, the data that has been
stored in the specified area up until that point is lost (if the data is written into
only one Bank, the other Bank will not be affected).
Method of Execution
Use the following procedure to write the screen data in the NT631/NT631C to
the Memory Unit by automatic transmission.
SW1-3
SW1-4
SW2-1
SW2-2
SW2-3
SW2-4
Switch
Switch
of areas (bank 0, bank 1). (The total data storage is for two PTs.) SW2-3
sets which of these two banks is used for automatic transmission.
• In the following cases, a mode setting error occurs.
• In the following case, a protect setting error occurs.
• In the following cases, a data transmission error occurs.
• For details on mode setting errors and protect setting errors, refer to
Transmitting to the write destination has been disabled by the setting for
SW2-1 or SW2-2.
Errors When Using a Memory Unit (page 45).
• More than one of the SW1-1 to SW1-3 switches are set to ON.
• None of the SW1-1 to SW1-3 switches are set to ON.
• An attempt is made to transmit data other than the system program to
• An attempt is made to transmit the system program to PT screen data
PT system program area.
area.
Manual transmission (Direction of transmission and
bank used selected at the PT touch panel)
Data type to transfer
Disable/enable writing to PT
Disable/enable writing to the Memory Unit
Area (bank) selection of automatic transmission. *
System/Screen simultaneous transmission
Function
Function
OFF: Not executed
ON: Executed
OFF: Screen data
ON: System program
OFF: Disable
ON: Enable
OFF: Disable
ON: Enable
OFF: Bank 0
ON: Bank 1
OFF: Disable
ON: Enable
Section 3-5
41