NSH5-232CW-3M Omron, NSH5-232CW-3M Datasheet - Page 85

• Manufacturer Part Number: NSH5-232CW-3M
• Description: HMI
• Manufacturer: Omron

Specifications of NSH5-232CW-3M

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

5-2
Cleaning
Inspection Interval
Inspection and Cleaning
Inspection and Cleaning
1,2,3...
Note
Note
Replacement Procedure
Use the following procedure to replace the battery.
1. Remove the back cover from the PT. The battery is located as shown in the
2. To replace the battery, remove the connector as shown below.
Replace the battery within five minutes of disconnecting it.
Clean and inspect the NSH5-series PT regularly to ensure that it is always
used under optimum conditions.
If the display gets dirty, the screen becomes difficult to read. Clean the screen
periodically as follows:
Never use chemical dusters or volatile solvents such as benzenes or thinners.
In normal environments, inspect the PT at intervals of six months to one year.
If the PT is used in an environment that is extremely hot and humid, or very
dusty, shorten the inspection interval.
• Wipe the display daily with a dry, soft cloth. If the soil is particularly heavy,
• If the soiling cannot be wiped off with a dry cloth, wet the cloth with diluted
• If rubber or vinyl products, tape, etc., are left stuck to the display for long
diagram below. (For details on removing the back cover, refer to 2-3 Con-
necting the Special Cable.)
attempting to remove it by wiping with a dry cloth may damage the front
sheet of the PT. In that case, wipe it with a damp cloth.
neutral detergent (2%) and wring it out well before using it.
periods, they will cause staining. If such items are stuck to the display,
remove them during cleaning.
Section 5-2
63