BK2534 B&K Precision, BK2534 Datasheet - Page 76

• Manufacturer Part Number: BK2534
• Description: OSCOPE 60MHZ DIGITAL STORAGE
• Manufacturer: B&K Precision
• Type: Bench, Digitalr

Specifications of BK2534

• Includes: Probes, Software, USB Cable
• Bandwidth: 60MHz
• Channels: Dual
• Display Type: LCD - Color
• Features: Software Controllable, USB Port, Waveform Capture
• Probe Type: PR-37A x1/x10/Ref Probes (2)
• Sampling Rate (per Second): 400MSa/s
• Input Impedance: 1M - 19pF
• Rise Time (typ): 5.83nS
• Voltage - Input, Max: 400Vpeak
• Voltage - Supply: 100 ~ 240VAC
• Lead Free Status / RoHS Status: Not applicable / Not applicable

4. System Message and
System Message
Function is not available: The control knob, key, or softkey
is not available under a specific operating condition.
The control is at its limit: This message will be displayed
when the maximum or minimum value is reached by turning
the Entry knob, Vertical Control knobs, Horizontal Control
knobs, or Trigger Level knob.
Total is at its maximun: This message will be displayed
when the maximum value of Total count for PASS/FAIL is
reached.
Record is completed: This message will be displayed when
the number of waveforms (set in the End Frame softkey)
have been recorded.
No external memory: This message will be displayed when
you try to save a file to an external mass storage device
which has not been installed.
Save error: This message will be displayed when a failure to
save a file to the internal or external memory occurs.
System Message and General Problems
General Problems
151
152
System Message and General Problems
Empty storage memory: This message will be displayed
when you try to load a file which does not exist from the
internal memory.
Unrecognized file: This message will be displayed when
you try to load a file which cannot be recognized by the
oscilloscope.
Update failed: This message will be displayed when a
software update has failed.
No record data: This message will be displayed when you
try to save a record file without record data.
Record is failed: This message will be displayed when
waveform record is failed.
Fatory setup is recalled: This message will be displayed
when the default factory configuration is recalled.
No signal is found: This message will be displayed when
you press the AUTO key without any signal connected to
either channel.
Invalid data: This message will be displayed when you try to
save a *.CSV file without any valid CSV data.
Load finished: This message will be displayed when a file
has been successfully loaded from the internal or external
memory.
Save finished: This message will be displayed when a file
has been successfully saved to the internal or external
memory.