HFBR-57M5AP Avago Technologies US Inc., HFBR-57M5AP Datasheet - Page 7

• Manufacturer Part Number: HFBR-57M5AP
• Description: Fiber Optic Transmitters, Receivers, Transceivers 2/1 GBd FC SFP DMI B ail delatch
• Manufacturer: Avago Technologies US Inc.

Specifications of HFBR-57M5AP

• Function: Supports high-speed serial links over multimode optical fiber at signaling rates up to 2.125 GBd.
• Product: Transceiver
• Data Rate: 2.125 GBd, 1.0625 GBd, 1.25 GBd
• Wavelength: 850 nm
• Maximum Rise Time: 250 ps, 150 ps
• Maximum Fall Time: 250 ps, 150 ps
• Pulse Width Distortion: 0.12 ns, 0.123 ns
• Operating Supply Voltage: 2.97 V to 3.63 V
• Maximum Operating Temperature: + 75 C
• Minimum Operating Temperature: - 10 C
• Package / Case: SFP-20
• Optical Fiber Type: TX/RX
• Data Transfer Rate: 2125Mbps
• Optical Rise Time: 0.15/0.25ns
• Optical Fall Time: 0.15/0.25ns
• Jitter: 0.12/0.123ns
• Operating Temperature Classification: Commercial
• Peak Wavelength: 860nm
• Package Type: SFP
• Operating Supply Voltage (min): 2.97V
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (max): 3.63V
• Operating Temp Range: -10C to 75C
• Mounting: Snap Fit To Panel
• Pin Count: 20
• For Use With: Multimode Glass
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Transceiver Electrical Characteristics
TC = -10 °C to +85 °C, V
Notes:
1. Internally ac coupled and terminated (100 Ohm differential).
2. Internally ac coupled but requires an external load termination (100 Ohm differential).
3. Contributed DJ is measured on an oscilloscope in average mode with 50% threshold and K28.5 pattern
4. Contributed RJ is calculated for 1x10-12 BER by multiplying the RMS jitter (measured on a single rise or fall edge) from the oscilloscope by
5. 20%-80% electrical rise & fall times measured with a 500 MHz signal utilizing a 1010 data pattern.
7
Parameter
Data Input:
Transmitter Differential Input Voltage (TD±)
Data Output:
Receiver Differential Output Voltage (RD±)
Contributed Deterministic Jitter (Receiver)
2.125 Gb/s
Contributed Deterministic Jitter (Receiver)
1.0625 Gb/s
Contributed Total Jitter (Receiver) 2.125 Gb/s
Contributed Total Jitter (Receiver) 1.0625 Gb/s TJ
Receive Data Electrical Rise & Fall Times
(Receiver)
14. Per FC-PI (Table 13 - MM jitter output, note 1), the actual contributed RJ is allowed to increase above its limit if the actual contributed DJ
decreases below its limits, as long as the component output DJ and TJ remain within their specified FC-PI maximum limits with the worst case
specified component jitter input.
CC
T, V
CC
R = 3.3 V ± 10%
Symbol
V
V
DJ
DJ
TJ
tr, tf
I
O
Minimum
350
500
Typical
100
Maximum
2400
2000
0.1
47
0.12
113
0.26
123
0.22
205
250
Unit
mV
mV
UI
ps
UI
ps
UI
ps
UI
ps
ps
Notes
1
2
3
3
4
4
5