SK-TSC-1127-SB Fujitsu, SK-TSC-1127-SB Datasheet - Page 8

• Manufacturer Part Number: SK-TSC-1127-SB
• Description: KIT, STARTER, TOUCH CNTRL, FMA1127
• Manufacturer: Fujitsu
• Type: Starter Kitr

Specifications of SK-TSC-1127-SB

• Mcu Supported Families: FMA1127
• Tool / Board Applications: Touch Sensor Controller
• Silicon Manufacturer: Fujitsu
• Kit Contents: SK-TSC-1127S-SB Touch Board, ADA-16FX-TSC-LCD, 10-pin Ribbon Cable, 3x FMA1127DC-30S Sample
• Features: 10-pin Connector For I2C And Interrupt Signals, Pin
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

SK-TSC-1127-SB User Guide
2.2 Setup (PC Software)
The installation of the USB driver is described in the SK-16FX-EUROSCOPE
documentation. In case the USB connection is only used as power supply, the driver
installation is optional. Communication with the demo firmware also is possible using the
standard RS232 connector (‘UART A’) on the SK-16FX-EUROSCOPE.
The newest version of the demo and tuning firmware can be downloaded at
http://www.fujitsu.com/emea/services/microelectronics/tsc/
The .mhx file from the archive can directly be programmed to the host MCU using the Flash
programmer on the SK-16FX-EUROSCOPE CD.
After power-up, the host MCU will start the initialization of the FMA1127 TSC. Two
parameter sets can be chosen: By default, parameters are loaded which allow the usage of
the SK-TSC-1127S-SB with no front plate or only a thin foil etc. The 7-segment displays will
show ‘P1’ during initialization. If the left button (SW2) is held during reset and until the TSC
initialization is finished (‘P2’ appears on the 7-segment display), a second parameter set is
loaded which is more sensitive, allowing thicker front panels (3-4mm acryl glass). The
parameters can be changed as described later.
After initialization, the LED displays on the SK-16FX-EUROSCOPE should show “--“,
indicating that no button is touched. After some seconds, the LEDs on the SK-TSC-1127S-
SB will start showing a moving light as long as the kit is idle.
The demo firmware for the MB96340 Series MCU on the SK-16FX-EUROSCOPE offers
several functions to support a quick and easy setup and tuning of the application. The
tuning process is explained more in detail later in this document.
Generally, the command line can be accessed by any PC terminal program. However, not all
terminal programs support the ‘form feed’ command to clear the screen; this is used for the
real-time monitoring modes. Therefore the Fujitsu ‘SK Wizard’ is recommended for tuning; it
can be downloaded free of charge at
http://mcu.emea.fujitsu.com/mcu_tool/software.htm
Communication settings for the serial port are 8N1 at 115200baud (8 bits, no parity, 1 stop
bit).
After connection to the starter kit, type ‘help’ followed by the ‘enter’ key for a list and short
description of available commands.
- 8 -
© Fujitsu Microelectronics Europe GmbH