INFS-0000-DC1 NEWPORT ELECTRONICS, INFS-0000-DC1 Datasheet - Page 69

• Manufacturer Part Number: INFS-0000-DC1
• Description: Strain Gauge Meter
• Manufacturer: NEWPORT ELECTRONICS

Specifications of INFS-0000-DC1

• No. Of Digits / Alpha: 6
• Meter Range: 0mV To 100mV
• Digit Height: 13.7mm
• Power Consumption: 6W
• Operating Temperature Range: 0°C To +50°C
• Signal Input Type: 0 To 100mV Voltage
• Lead Free Status / RoHS Status: na

NOTE: If after zeroing the display with RDF OF, the reading again
drifts from zero, the required offset value is the sum of the current
RDG OF value and the current converted offset value. The ex-
amples below illustrate the calculation of required offset values
when using an independent decimal. If you are using an active
decimal point, the current converted offset value is simply the
negative value of the display reading.
Example 1: You use a RDG OF value of -1.0000 to zero the meter.
The next morning, the meter displays 00.0008 at zero input; you
need to rezero. The current count value is 000008; shifting this
value to the left of the decimal makes it 08.0000, and making the
value negative makes it -8.0000. The required RDG OF value is the
sum of the current RDG OF value (-1.0000) and the current
converted offset value (-8.0000):
Example 2: You use a RDG OF value of -1.0000 to zero the meter.
The next morning, the meter displays -0.0008 at zero input; you
need to rezero. The current count value is -00008; shifting this
value to the left of the decimal makes it -8.0000, and making the
value positive makes it 08.0000. The required RDG OF value is
sum of the current RDG OF value (-1.0000) and the current
converted offset value (08.0000):
If you require further configuration(s) for your specific application,
refer to Sections 9 through 21.
NOTE: Should you receive an error code of any kind while
configuring your meter, refer to Section 17 - Troubleshooting -
Display Messages and Troubleshooting Guide.
-1.0000 + -8.0000 = -9.0000
-1.0000 + 08.0000 = 07.0000
8-25
Scaling to
Display
Engineering
Units
8