INFS-0000-DC1 NEWPORT ELECTRONICS, INFS-0000-DC1 Datasheet - Page 45

• Manufacturer Part Number: INFS-0000-DC1
• Description: Strain Gauge Meter
• Manufacturer: NEWPORT ELECTRONICS

Specifications of INFS-0000-DC1

• No. Of Digits / Alpha: 6
• Meter Range: 0mV To 100mV
• Digit Height: 13.7mm
• Power Consumption: 6W
• Operating Temperature Range: 0°C To +50°C
• Signal Input Type: 0 To 100mV Voltage
• Lead Free Status / RoHS Status: na

8. Methods for Scaling the Meter to
8.1 INTRODUCTION
8.2 SETUP METER INPUT TYPE AND RANGE
Display in Engineering Units
There are two basic methods for scaling your meter to display
engineering units; scaling by using measured input values or scaling
without connecting a sensor using assumed input values. Both
methods use the Input Scale and Offset (“IN.SC.OF”) method.
If you have received your meter setup for your required input and
do not require changes or rescaling, skip this section entirely and
proceed with the normal use of your meter.
If you received your meter and you only require a scaling change,
proceed with the steps in Section 8.2.2.
If you received your meter and it is has been configured for an input
other than what you require, you must proceed with the following
steps before rescaling the display:
WARNING: You must set your jumper positions at the S1 and S2
positions BEFORE proceeding. Refer to Section 6 for jumper
positions.
8-1
Scaling to
Display
Engineering
Units
8