INFS-0000-DC1 NEWPORT ELECTRONICS, INFS-0000-DC1 Datasheet - Page 47

• Manufacturer Part Number: INFS-0000-DC1
• Description: Strain Gauge Meter
• Manufacturer: NEWPORT ELECTRONICS

Specifications of INFS-0000-DC1

• No. Of Digits / Alpha: 6
• Meter Range: 0mV To 100mV
• Digit Height: 13.7mm
• Power Consumption: 6W
• Operating Temperature Range: 0°C To +50°C
• Signal Input Type: 0 To 100mV Voltage
• Lead Free Status / RoHS Status: na

8.3.1 SETTING INPUT CONFIGURATION (IN CNF)
An example would be a 4-wire pressure transducer or load cell that
sends an output signal of 0-100 mVdc. With a signal input of “0
mVdc”, the display will show “000000”and when a signal input of
100 mVdc is applied, the meter will display “100000”.
NOTE: Your display may not show exactly “000000” and may
display a negative number such as “–000015” or a positive number
such as “000023”.
Using Input Scale and Offset (“IN.SC.OF”) allows you to accu-
rately scale your input signal to display in any engineering units you
require.
NOTE: Although the full span input of your sensor signal is
preferred for maximum resolution, you may record any two points
within the signal span for scaling accurately into engineering units.
The following will walk you step by step in configuring your meter
for scaling your meter using the Input Scale and Offset
(“IN.SC.OF”) procedure.
PRESS
‘MENU’
‘MIN’
THEN PRESS
(TO CHANGE DISPLAY
IF REQUIRED) SHOWS
8-3
UNTIL
“IN CNF”
“INP.3=0”
COMMENTS
Press the ‘MENU’
button until the
display shows
“IN CNF”.
Press the ‘MIN’
button until the
display shows
“INP.3=0” or
“INP.3=1”.
continued next page
Scaling to
Display
Engineering
Units
8