NT30-KBA01 Omron, NT30-KBA01 Datasheet - Page 32

• Manufacturer Part Number: NT30-KBA01
• Description: CHEMICAL RESISTANT COVER FOR NT31
• Manufacturer: Omron

Specifications of NT30-KBA01

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2-2-2 Power Supply Connection
20
Installation
Caution
(1) Open a hole, shown below, in the panel and install the NT30/30C from the
(2) Attach the panel fittings at four positions for the upper/lower sides and at two
Connect a 24 VDC power supply to the power input terminals.
S Noise Prevention
S Power Supply
S Do not apply an AC power supply across the power supply terminals.
S Use a DC power supply with a low voltage fluctuation stipulation
S When complying with EC directives (low voltage directives) use a power sup-
S Carefully check the wiring before switching ON the power.
The NT30/30C has a noise preventive feature against the power supply line
noise. To further reduce noise, connect a noise filter to the power line.
In order to comply with EC directives, use a SELV power supply.
Applicable power supply specifications are as follows.
ply with reinforced insulation.
24 VDC
Power supply voltage
Allowable power supply voltage
fluctuation range
Power supply capacity
front side of the panel.
positions for the right and left sides, shown below, on the rear side of the
NT30/30C.
Fit the hook of the fitting in the square hole in the body and tighten the screw
with a Phillips head screwdriver while lightly pulling the fitting.
SW2
PRINTER
+
184.0
RESET
- -CONTRAST
RS-232C
+0.5 mm
0 mm
SDA SDB RD
A
Item
RDB
24 VDC
131.0
+0.5 mm
0 mm
24 VDC Power Supply
Breaker
24 VDC
20.4 VDC to 26.4 VDC
(24 VDC --15%, +10%)
15 W or over
Value
Section
2-2