NT30-KBA01 Omron, NT30-KBA01 Datasheet - Page 100

• Manufacturer Part Number: NT30-KBA01
• Description: CHEMICAL RESISTANT COVER FOR NT31
• Manufacturer: Omron

Specifications of NT30-KBA01

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3-6
Transmission - - Transmission in File Units
Transmitting the Screen Data from the NT-series Support Tool
Registering the Screen Data
Registering the Screen Data
Reference
S Exist:
The screen data is created by using the NT-series Support Tool and registered to
the NT30/30C screen data memory. This section describes the procedure to reg-
ister the screen data to the NT30/30C. For the screen data creation and NT-se-
ries Support Tool operation, refer to the NT-series Support Tool Operation Manu-
al.
The NT30/30C uses several screens that are switched on its display. The screen
data of one NT30/30C PT corresponds to the files created by using the NT-series
Support Tool. Select a file that contains the screen data to be transmitted when
selecting the screen data to be transmitted to the NT30/30C so that the required
screen data can be transmitted to the NT30/30C.
When the screen data is transmitted from the NT-series Support Tool to the
NT30/30C, the screen data already existing in the NT30/30C will be erased. The
NT30/30C cannot transmit the screen data in units of screens.
If an error message and the System Menu are displayed immediately after the
NT30/30C has been started, the screen data memory needs to be initialized.
To transmit the screen data from the NT-series Support Tool to the NT30/30C,
connect the NT30/30C to the computer on which the NT-series Support Tool is
being used, and follow the procedure below.
S When screen data transmission is performed, the NT30/30C screen data
S The NT30/30C uses the same connector for screen data transfer and
memory is automatically initialized before the new screen data is transmitted.
There is therefore no need to initialize the screen data memory using menu
operations before transmitting the screen data.
RS-232C connection to the PC. If this connector is currently being used for
RS-232C connection to the PC, disconnect the cable from the PC, connect it to
the NT-series Support Tool (personal computer), then transmit the screen
data.
Direct information
Screen 1
Screen 2
Screen N
Memory tables
Mark data
Image data
Library data
System memory
data file
Screen
:
If a communication error has occurred, corresponding error mes-
sage will not be displayed and the operation will be automatically
reset. However, the message “Connecting To Host” may be dis-
played.
All screen data are
transmitted by one operation.
Direct information
Screen 1
Screen 2
Screen N
Memory tables
Mark data
System memory
Image data
Library data
NT30/30C
:
Section
3-6
89