ST62T15CM6 STMicroelectronics, ST62T15CM6 Datasheet - Page 34

• Manufacturer Part Number: ST62T15CM6
• Description: 8BIT MCU OTP 2K, SMD, 62T15, SOIC20
• Manufacturer: STMicroelectronics

Specifications of ST62T15CM6

• Controller Family/series: ST6
• Core Size: 8bit
• No. Of I/o's: 20
• Program Memory Size: 2KB
• Ram Memory Size: 64Byte
• Cpu Speed: 8MHz
• Oscillator Type: External Only
• No. Of Timers: 1
• Digital Ic Case: RoHS Compliant
• Peripherals: ADC,
• Rohs Compliant: No
• Processor Series: ST62T1x
• Core: ST6
• Data Bus Width: 8 bit
• Program Memory Type: EPROM
• Data Ram Size: 64 B
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 20
• Number Of Timers: 2
• Operating Supply Voltage: 3 V to 6 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SOP-28
• Development Tools By Supplier: ST62GP-EMU2, ST62E2XC-EPB/110, ST62E6XC-EPB/US, STREALIZER-II
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit
• Lead Free Status / Rohs Status: In Transition

ST6215C/ST6225C
7.2 WAIT MODE
The MCU goes into WAIT mode as soon as the
WAIT instruction is executed. This has the follow-
ing effects:
– Program execution is stopped, the microcontrol-
– RAM contents and peripheral registers are pre-
– The oscillator is kept running to provide a clock
WAIT mode can be used when the user wants to
reduce the MCU power consumption during idle
periods, while not losing track of time or the ability
to monitor external events. WAIT mode places the
MCU in a low power consumption mode by stop-
ping the CPU. The active oscillator (main oscillator
or LFAO) is kept running in order to provide a clock
signal to the peripherals.
If the power consumption has to be further re-
duced, the Low Frequency Auxiliary Oscillator
(LFAO) can be used in place of the main oscillator,
if its operating frequency is lower. If required, the
LFAO must be switched on before entering WAIT
mode.
Exit from Wait mode
The MCU remains in WAIT mode until one of the
following events occurs:
– RESET (Watchdog, LVD or RESET pin)
– A peripheral interrupt (timer, ADC,...),
– An external interrupt (I/O port, NMI)
The Program Counter then branches to the start-
ing address of the interrupt or RESET service rou-
tine. Refer to
See also
34/105
1
ler software can be considered as being in a “fro-
zen” state.
served as long as the power supply voltage is
higher than the RAM retention voltage.
to the peripherals; they are still active.
Section
Figure
7.4.1.
20.
Figure 20. WAIT Mode Flowchart
WAIT INSTRUCTION
N
INTERRUPT
Y
OR SERVICE INTERRUPT
OSCILLATOR
Clock to PERIPHERALS
Clock to CPU
OSCILLATOR
Clock to PERIPHERALS
Clock to CPU
OSCILLATOR
Clock to PERIPHERALS
Clock to CPU
FETCH RESET VECTOR
N
CLOCK CYCLE
RESET
Y
DELAY
2048
Restart
Yes
Yes
Yes
Yes
Yes
On
No
On