ML610Q412P-NNNTB03A7 Rohm Semiconductor, ML610Q412P-NNNTB03A7 Datasheet - Page 259

• Manufacturer Part Number: ML610Q412P-NNNTB03A7
• Description: MCU 8BIT 16K FLASH 120-TQFP
• Manufacturer: Rohm Semiconductor

Specifications of ML610Q412P-NNNTB03A7

• Core Processor: nX-U8/100
• Core Size: 8-Bit
• Speed: 625kHz
• Connectivity: I²C, SSP, UART/USART
• Peripherals: LCD, POR, PWM, WDT
• Number Of I /o: 14
• Program Memory Size: 16KB (8K x 16)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 1.1 V ~ 3.6 V
• Data Converters: A/D 2x12b, 2x24b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

20.3 Description of Operation
20.3.1
20.3.2
For each pin of Port 3, either output or input is selected by setting the Port 3 direction register (P3DIR).
In output mode, high-impedance output mode, P-channel open drain output mode, N-channel open drain output mode,
or CMOS output mode can be selected by setting the Port 3 control registers 0 and 1 (P3CON0 and P3CON1).
In input mode, high-impedance input mode, input mode with a pull-down resistor, or input mode with a pull-up resistor
can be selected by setting the Port 3 control registers 0 and 1 (P3CON0 and P3CON1).
At a system reset, high-impedance output mode is selected as the initial state.
In output mode, “L” or “H” level is output to each pin of Port 3 depending on the value set by the Port 3 data register
(P3D).
In input mode, the input level of each pin of Port 3 can be read from the Port 3 data register (P3D).
Secondary and tertiary functions are assigned to Port 3 as the RC-ADC (channel 0) oscillation pins (IN0, CS0, RS0,
RT0, RCT0, RCM) and the PWM output pin (PWM0). These pins can be used in a secondary or tertiary function
mode by setting the P35MD0 to P30MD0 bits and the P35MD1 to P30MD1 bits of the Port 3 mode registers (P3MOD0,
P3MOD1). For RC-ADC and PWM, see Chapter 24, “RC Oscillation Type A/D converter”, and Chapter 11, “PWM”.
Note:
All the port 3 pins except P35/RCM are configured as pins dedicated to the RC-ADC function during A/D conversion.
Therefore, if there is any unused pin, that pin cannot be used as its primary function during A/D conversion. For the
RC-ADC, see Chapter 24, “RC Oscillation Type A/D Converter”.
Input/Output Port Functions
Secondary and Tertiary Functions
20 – 10
ML610Q411/ML610Q412/ML610Q415 User’s Manual
Chapter 20 Port 3