AVR-ISP500-TINY Olimex Ltd., AVR-ISP500-TINY Datasheet - Page 2

• Manufacturer Part Number: AVR-ISP500-TINY
• Description: Programmers & Debuggers AVR PROGRAMMER 2MB FLASH
• Manufacturer: Olimex Ltd.

Specifications of AVR-ISP500-TINY

• Positions/sockets: 1
• Description/function: USB AVR Programmer
• Tool Type: Programmer
• Core Architecture: AVR
• Ic Product Type: Programmer, In-Circuit
• Supported Families: AVR, MegaAVR, TinyAVR
• Ic Interface Type: USB
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: AVR Studio
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 1701517 25R4412

INTRODUCTION:
FEATURES:
ELECTROSTATIC WARNING:
REQUIREMENTS:
AVR-ISP500-TINY is USB in-system programmer for AVR microcontrollers,
featuring two distinctive methods for communication with PC programming
software.
It can implement the STK500v2 protocol as defined by Atmel which makes
it compatible with a range of tools, including
is distinguished from other programmers by its support for autonomous
operation. AVR-ISP500-TINY contains a 2Mb FLASH memory where it can
store entire programming sessions, including FUSE, LOCK, EEPROM and
FLASH write and verification, as well as signature checking. Just hold the
button, perform all the necessary steps with AvrStudio, and disconnect the
programmer from the PC. Next time button is pressed the programmer will
invoke all previously recorded steps without the need for connection to the
PC.
The other supported mode is a USB mass storage FLASH drive where user
can drag and drop HEX files for downloading to target AVR chip.
We believe these features make AVR-ISP500-TINY the perfect low-cost tool
for firmware upgrades in remote places.
-
-
-
-
-
-
-
-
-
-
-
-
-
The AVR-ISP500-TINY board is shipped in protective anti-static packaging.
The board must not be subject to high electrostatic potentials. General
practice for working with static sensitive devices should be applied when
working with this board.
Cables: 1.8 meter USB A-B cable. Ten- or six-wire ribbon cable for
connection to target AVR chip. USB power supply cable for autonomous
operation.
Fully STK500v2 compatible;
Works with AvrStudio, WinAVR, Avrdude and every other software
compatible with STK500v2;
Two distinctive modes of operation;
Modes of operation (STK500v2 and Mass Storage Drive) are switched
easily by uploading firmware images available from our website;
USB port for connection to PC;
Stand alone operation without the need for PC connection, allowing
firmware mass programming on many devices with single button press;
One bi-color LED for current operation status;
Supports both standard ICSP10 and ICSP6 connectors;
Button for initiating autonomous operations and command logging;
Powered by USB;
External clock output on ICSP10 pin 3 for rescuing AVRs with enabled
external clock fuse;
Supports target voltages ranging from 1.8V to 5.5V.
ISP clock frequencies ranging from 5kHz to 2MHz.
AvrStudio
and
avrdude
. It