AVR-CAN Olimex Ltd., AVR-CAN Datasheet - Page 2

• Manufacturer Part Number: AVR-CAN
• Description: MCU, MPU & DSP Development Tools DEV BRD FOR AT90CAN128
• Manufacturer: Olimex Ltd.

Specifications of AVR-CAN

• Processor To Be Evaluated: AT90CAN128
• Data Bus Width: 8 bit
• Interface Type: RS-232, CAN, SPI, UART
• Dimensions: 60 mm x 50 mm
• Operating Supply Voltage: 5 V
• Tool Type: Development Kit
• Cpu Core: AVR 8
• Core Architecture: AVR
• Silicon Manufacturer: Atmel
• Silicon Core Number: AT90
• Silicon Family Name: AT90xxx
• Kit Contents: Board
• Features: CAN Controller And Interface, On Board Voltage Regulator
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 1776310 52R3433

INTRODUCTION:
BOARD FEATURES:
ELECTROSTATIC WARNING:
BOARD USE REQUIREMENTS:
AVR-CAN is inexpensive way to learn AT90CAN128 microcontroller from Atmel.
It's in very compact form 60x55mm and the presence of both CAN and RS232
allows the customer to make a bridge between UART and CAN networks. All AVR
pins are available on extension connectors and the board can be easily a snap-on
prototype or other mother board where additional circuits are built.
The AVR-CAN board is shipped in protective anti-static packaging. The board must
not be subject to high electrostatic potentials. General practice for working with
static sensitive devices should be applied when working with this board.
Cables:
Hardware:
Software:
MCU: AT90CAN128 – 128Kb Flash, 4Kb EEPROM, 4Kb SRAM, 52 GPIO, 32
working registers, a CAN controller, Real Time Clock, four Timer/Counters
with PWM, 2 UARTs, Two-wire Serial Interface, an 8-channel 10-bit ADC,
Watchdog Timer, SPI serial port, JTAG interface, five selectable power saving
modes
RS232 DB9 female connector and driver
CAN controller and interface
User button
Status LED
16 MHz oscillator circuit
32768 Hz oscillator circuit
Reset button and circuit
On board voltage regulator (+5V)
Power supply LED
Power supply connector
Extension pin headers for every uC pin
FR-4, 1.5 mm (0.062''), soldermask, white silkscreen component print
Dimension 60x50 mm (2.36x1.96'')
5x2 pin JTAG connector for programming and debugging with AVR-JTAG-L or
AVR-JTAG-USB
RS232 cable in case you want to use the RS232 and/or CAN interface.
You might need other cables depending on the
programming/debugging tool you use.
Programmer/Debugger – AVR-JTAG-L or AVR-JTAG-USB or other
compatible programming/debugging tool.
AVR Studio 4.13 (or later) + WinAVR (latest version) or IAR AVR.
AVR Studio and WinAVR are free to download and use. Take a note
that AVR Studio 4.13 has a bug and doesn't read the fuses correctly.
On our request to Atmel support they had confirmed the bug and
Page 2