AVR-P28N-8MHz Olimex Ltd., AVR-P28N-8MHz Datasheet - Page 2

• Manufacturer Part Number: AVR-P28N-8MHz
• Description: MCU, MPU & DSP Development Tools PROTOTYPE BRD FOR STK200 28PIN
• Manufacturer: Olimex Ltd.

Specifications of AVR-P28N-8MHz

• Processor To Be Evaluated: AVR-PG1, AVR-PG2
• Data Bus Width: 8 bit
• Interface Type: RS-232
• Dimensions: 100 mm x 80 mm
• Operating Supply Voltage: 3.3 V, 5 V
• External Height: 80mm
• External Width: 100mm
• Mcu Supported Families: AVR
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 1776315 52R3438 AVR-P28-8MHZ

INTRODUCTION:
BOARD FEATURES:
ELECTROSTATIC WARNING:
BOARD USE REQUIREMENTS:
The AVR-P28 board is shipped in protective anti-static packaging. The board must
not be subject to high electrostatic potentials. General practice for working with
static sensitive devices should be applied when working with this board.
Cables: The cable you will need depends on the programmer/debugger you use. If
you use AVR-PG1, you will need RS232 cable, if you use AVR-PG2, you will need
LPT cable, if you use AVR-ISP500,
need 1.8 meter USB A-B cable.
the RISC architecture. The AVR core combines a rich instruction set with general
purpose working registers. All the registers are directly connected to the Arithmetic
Logic Unit (ALU), allowing two independent registers to be accessed in one single
instruction executed in one clock cycle. The resulting architecture is more code
efficient while achieving throughputs up to ten times faster than conventional CISC
microcontrollers.
compatible 10 pin ICSP connector
The AVR Microcontrollers are low-power CMOS 8-bit controller based on
AVR-P28 is prototype board for 28 pin AVR microcontrollers with STKxxx
ICSP 5x2 pin connector for in-circuit programming with AVR-PG1B or
AVR-PG2B
RS232 Tx, Rx interface with MAX232 IC on socket
power supply filtering capacitors
8MHz crystal on socket
reset IC ZM33064
reset button
general purpose push button
status LED connected via removable jumper
DIL28 microcontroller socket
extension pin headers for each uC pin
four mounting holes 3.3 mm (0.13")
FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component print
dimensions 100x80 mm (3.9x3.15")
Page 2
.
AVR-ISP500-TINY
or AVR-ISP500-ISO, you will