LS013B4DN02 Sharp Microelectronics, LS013B4DN02 Datasheet - Page 6

• Manufacturer Part Number: LS013B4DN02
• Description: LCD Graphic Display Modules & Accessories 1.35 96x96 w/ FPC Mono Memory LCD
• Manufacturer: Sharp Microelectronics

Specifications of LS013B4DN02

• Pixel Density: 96 x 96
• Module Size (w X H X T): 28.2 mm x 32.34 mm x 1.4 mm
• Viewing Area (w X H): 24.192 mm x 24.192 mm
• Attached Touch Screen: No
• Product: Graphic LCD Module
• Interface: Serial
• Operating Temperature Range: - 20 C to + 70 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

FPC
LCD Panel
(1) Operation outside specified environmental conditions cannot be guaranteed.
(2) As power supply (VDD-GND、VDDA-GND) impedance is lowered during use, bus controller should be inserted
(3) UV protection film is applied over LCD panel surface.
(4) Disassembling the LCD module will cause permanent damage to the module. Do not disassemble the module.
(5) If LCD panel is broken, do not ingest the liquid crystal from the broken panel. If hand, leg, or clothes come in
(6) ODS (specific chlorofuorocarbon, specific halon, 1-1-1 trichloroethane, carbon tetrachloride) are not used or
(7) Observe all other precautionary requirements in handling general electronic components.
near LCD module as much as possible.
ultraviolet ray. The panel should not be left in direct sun or under strong ultraviolet ray for prolonged period of
time even with the UV protection film.
contact with liquid crystal, wash off immediately with soap.
contained in material or all production processes of this product.
:
: Dispose of as glass waste. This LCD module contains no harmful substances.
The liquid crystal panel contains no dangerous or harmful substances.
This liquid crystal panel contains only an extremely small amount of liquid crystal
(1) FPC bend R should be 0.45mm or greater and R should be even.
(2)Do not hang LCD module by FPC or apply force to FPC.
(approximately 100mg) and therefore it will not leak even if the panel should
break.
Its median lethal dose (LD50) is greater than 2,000 mg/kg and a mutagenetic
(Aims test: negative) material is used.
In LCD panel an connective area, do not bend FPC into UV protection film side.
Discarding liquid crystal modules
SPEC No.
LCY-12T09303B
[Other Notice]
Liquid crystal inside LCD panel deteriorates with
MODEL No.
LS013B4DN02
PAGE
5