ZSE40-T1-62 SMC Corporation of America, ZSE40-T1-62 Datasheet - Page 6

• Manufacturer Part Number: ZSE40-T1-62
• Description: SENSOR VACUUM 101.3KPA PNP/ ANLG
• Manufacturer: SMC Corporation of America
• Series: ZSE40r

Specifications of ZSE40-T1-62

• Pressure Type: Vacuum
• Operating Pressure: -14.65 ~ 1.45 PSI, -101 ~ +10 kPa
• Port Size: Female, 1/8" (3.175mm) NPT
• Output: Digital
• Voltage - Supply: 12 V ~ 24 V
• Termination Style: Cable with Connector
• Operating Temperature: 0°C ~ 50°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 606-1011

Calibration Procedures
16-2-22
Series
Auto Preset (In the case of confirming the supply pressure)
ON point (C, C1)
Press the “SET” button for 4
seconds or longer.
Release it when the display
turns to “
Other Functions
Initiate key lock
Key lock mode
Peak mode
Zero clear
OFF
”.
ZSE40/ISE40
ON point = C, C1
OFF point = C-3 digits, C1-3 digits
(1 digit is the minimum setting unit.)
While displayed, pressing the
second or longer causes the peak mode to
display and blink.
Pressing the
or longer reinstates it.
Note) Displaying the peak and the bottom
Pressing the
with the supply pressure released to the
atmosphere, causes it to reset to zero on the
display
operation. The function then returns to the
measurement mode.
Allows holding of the maximum pressure
value on display under measurement.
Display “
button or
Allows an adjust to zero on the display
if the pressure to be measured is
within a range of ±70 digits from the
atmospheric pressure.
display is not distinguished.
Used to avoid a malfunction when buttons on the front part of the switch are pressed.
Hysteresis (3 digits)
Select the Auto preset mode in
the initial setting mode and
press the “SET” button until
“
1. Auto preset mode
and
” is displayed.
button once again for 1 second
completes
+
button.
” by pressing
buttons simultaneously
the
Press the
to complete the setting.
button for 1
zero
Press the
SET
clear
“SET”
SET
“SET”
button
button.
4. Preparation for auto preset
2. Preparation for auto preset
Prepare the equipment for use
under operating conditions.
When setting OUT1 is not
required, press both the
button
simultaneously in this state to
skip to “
Prepare the equipment for use
under operating conditions of
OUT2.
When setting OUT2 is not
required, press both the
button
simultaneously in this state to
skip to the measurement mode.
Press the “SET” button for 4
seconds or longer.
Release it when the display
turns to “
Release key lock
Bottom mode
and
and
”.
”.
button
button
Press the
Press the
SET
“SET”
SET
“SET”
While displayed, pressing the
second or longer causes the bottom mode to
display and blink.
Pressing the
or longer reinstates it.
Note) Displaying the peak and the bottom
button.
3. Auto preset of OUT1
5. Auto preset of OUT2
Allows holding of the minimum pressure
value on display under measurement.
button.
Display “
button or
The pressure is read and the
optimal set value is determind
automatically.
The pressure is read and the
optimal set value is determind
automatically.
display is not distinguished.
button once again for 1 second
button.
” by pressing
Press the “SET” button
to complete the setting.
Press the “SET” button
to complete the setting.
button for 1
SET
SET